Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
5
6
PATIO BASE POST ASSEMBLY
12
Arrange with your local gas company to have a
gas supply line connected to the inlet of the flex
tube. The gas supply must have a shutoff valve
inside the wall and must be shutoff when the grill
is not in use.
Use pipe thread sealant or Teflon tape at the
threads of each connection being careful to not
allow any of these materials into the flare seat.
Test for gas leaks as directed by the grill’s Owner
Manual.
THE GRILL AND ITS INDIVIDUAL SHUTOFF VALVES MUST
BE
DISCONNECTED FROM THE GAS SUPPLY PIPING
SYSTEM
DURING ANY PRESSURE TESTING OF THAT
SYSTEM
AT TEST PRESSURES IN EXCESS OF ˚ PSIG.
Attach the retainer bracket to the slide with a wing
nut as shown by Figure 5.
Fasten the four ˘-20 x 1
3
/4" short eyebolts (4) to
the top of the square post using hex head bolts
(5), flat washers (1), lock washers (2), and nuts
(3).
Position the grill head onto the eyebolts and fasten
with lock washers (2) and nuts (3). F
IGURE 3.
4
THE GRILL MUST BE ISOLATED FROM THE GAS SUPPLY
PIPING
SYSTEM BY CLOSING ITS INDIVIDUAL MANUAL
SHUTOFF
VALVES DURING ANY PRESSURE TESTING OF
THE
GAS SUPPLY PIPING SYSTEM AT TEST PRESSURES
EQUAL TO OR LESS THAN ˚ PSIG.
WARNING: DO NOT SUPPLY LP GAS TO A GRILL
DESIGNED
FOR NATURAL GAS OR NATURAL GAS TO A
GRILL
DESIGNED FOR LP GAS.
3
4
2
6
GRILL
BOTTOM
FIGURE 3
12
FIGURE 4
FIGURE 5
13
13
9
9