Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
B100539-2-0610Page 10
fi G u r e 12
17
Installing "Tee" Connector
The pressure regulator has an outlet pressure of not
more than eleven (11") inches water column. It must
be connected to the propane gas cylinder’s female
valve outlet before the grill and side burner can be
operated.
ca u t i O n : OP e r a t i O n O f a P r O P a n e G a S G r i l l a n d S i d e
B u r n e r w i t h O u t t h e P r e S S u r e r e G u l a t O r a n d h O S e
a S S e M B l y w i l l c a u S e G a S l e a k S w h i c h c O u l d l e a d t O
f i r e O r e x P l O S i O n , r e S u l t i n G in P r O P e r t y d a M a G e O r
P e r S O n a l i n j u r y .
The pressure regulator’s tting must remain clean and
free of nicks and scratches. A dirty, nicked or scratched
tting can cause a gas leak, resulting in an explosion or
re. Use only genuine Broilmaster
®
replacement parts
unless otherwise specied by the manufacturer.
Pressure Regulator and Hose
Assembly
If your grill is equipped with a factory installed gas "tee"
behind the grill’s control panel, please skip to the next
section.
Turn OFF the gas valve at the propane cylinder.
Disconnect the regulator and hose assembly from the
cylinder. Disconnect hose from the gas valve located
under the grill’s control panel. F
i g u r e 9.
Attach one end of the 10" S/S ex line (18) to the end
of the grill’s gas valve. Attach the other end of the S/S
ex line to the brass "tee" (17). F
i g u r e 10.
N
o t e : Gr i l l s m a N u f a c t u r e d p r i o r t o 1999 m a y r e q u i r e
t h e a lt e r N a t e "t e e " c o N N e c t o r .
Attach the regulator and hose assembly to the brass
tee" (17). Reconnect the assembly to the cylinder. Use
two adjustable wrenches to hold and tighten the joint
between the hose and "tee". Fi g u r e 12.
Connecting to Propane Gas
Attach one end of the 34" S/S ex line (19) to the end
of the side burner valve (14). Attach the remaining
end of the hose to the "tee" (17) and use two wrenches
to tighten the S/S ex line connections. One wrench
should be used to turn the S/S ex line connector while
the "tee" or valve is held with the second wrench. Fig-
u r e 11.
fi G u r e 10
Grill Gas Valve
"Tee" (17)
10" S/S ex line (18)
fi G u r e 9
Grill Gas Valve
Hose Assembly
For old Broilmaster grill, this alternate tee tting kit must
be ordered.
fi G u r e 11
34" S/S ex line (19)
"Tee" (17)
14
PROPANE GAS CONNECTION