Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
WARNING
8
6. Check each place listed (A -J) for growing bubbles which indicates a leak.
7. Turn OFF gas supply at cylinder valve.
8. Turn on control knob to release gas pressure in hose.
9. Turn control knob to “off” position.
10. Tighten any leaking connections.
11. Repeat soapy water test until no leaks are detected. DO NOT use the grill if leaks cannot be stopped.
Contact a qualified gas appliance repair service.
12. Turn OFF gas supply at cylinder valve until you are ready to use your grill.
13. Wash off soapy residue with cold water and towel dry.
14. Wait 5 minutes to allow all gas to evacuate the area before lighting grill.
NOTE: The leak test must be performed in an area that has adequate lighting in order to see if
bubbles are developing. DO NOT use a flashlight to check for bubbles.
PRE-START CHECK LIST:
Property damage, bodily harm, severe burns, and death could result from failure to follow these
safety steps. These steps should be performed after the grill has been assembled, stored, moved,
cleaned, or repaired. DO NOT operate this grill until you have read and understand ALL of the
warnings and instructions in this manual.
• Insure that the grill is properly assembled.
• Check burner venturi tube for blockage from insect nests. See section on "Cleaning and
Maintenance".
• Check that burner venturi are seated properly over the valve outlet as shown
in the assembly instructions. The orifice must be inside the burner venturi for proper air/fuel mixing.
• Inspect the gas supply hose for burns, chaffing, kinks, and proper routing before each use. Hoses
should be at least 3 inches from hot surfaces.
• Leak check all gas connections and hoses. See section on "Leak Testing".
• Ensure that all electrical supply cords are properly grounded and are kept away from water and hot
surfaces.
• Position your grill on level ground in a well ventilated location, a safe distance from combustible
materials and buildings.
• Properly place an empty grease collection cup under the grease drain hole in the bottom of the
grill to catch grease during use.
• Your grill is covered with a plastic film to protect the stainless steel finish during shipment and
assembly. This plastic film must be removed before operating your grill.