Brinkmann 2210 Series Gas Grill User Manual


  Open as PDF
of 32
 
26
Note: When performing Step 10,
Lift grill body from front and
rear panels to avoid injury to
hands and fingers. Be sure
to pass hose/regulator
assembly above cart frame
crossbar.
Step 10
With the help of a friend, place grill
body assembly on preassembled
cart frame. Grill body will rest on
angled top of vertical supports.
Align bolt holes located on the
outside of the grill body assembly.
Secure using four M6 X12mm bolts
with small star washers.
ELECTRONIC IGNITER
FOR ASSISTANCE,
CALL 800-527-0717
FOR OUTDOOR
USE ONLY
BURNERCENTER
7. To light the left and right
burners, push and turn
control knobs to HIGH.
Follow Step 6.
8. Refer to owner’s manual
for match lighting
procedure.
9. To turn off, turn each
control knob clockwise
until it locks in OFF
position.
NOTE: Turn off LP supply
at cylinder when
appliance is not in use.
GRILL LIGHTING INSTRUCTIONS:
1. Read and follow all warnings
and instructions in owner’s
manual before lighting.
2. Open lid before lighting burner.
3. Make sure all control knobs are
in the OFF position.
NOTE: The CENTER BURNER must
be lit first, then light the left and
right burners.
4. Push and turn the control knob for
the CENTER BURNER to HIGH.
5. Press the electronic igniter and
hold for 3-5 seconds to light burner.
6. If ignition does not occur in
5 seconds, turn control knob
to OFF, wait 5 minutes to allow gas
to dissipate and repeat lighting
procedure.
Grill Body
Assembly
ELECTRONIC IGNITER
FOR ASSISTANCE,
CALL 800-527-0717
FOR OUTDOOR
USE ONLY
BURNERCENTER
7. To light the left and right
burners, push and turn
control knobs to HIGH.
Follow Step 6.
8. Refer to owner’s manual
for match lighting
procedure.
9.To turn off, turn each
control knob clockwise
until it locks in OFF
position.
NOTE: Turn off LP supply
at cylinder when
appliance is not in use.
GRILL LIGHTING INSTRUCTIONS:
1. Read and follow all warnings
and instructions in owner’s
manual before lighting.
2. Open lid before lighting burner.
3. Make sure all control knobs are
in the OFF position.
NOTE: The CENTER BURNER must
be lit first, then light the left and
right burners.
4. Push and turn the control knob for
the CENTER BURNER to HIGH.
5. Press the electronic igniter and
hold for 3-5 seconds to light burner.
6. If ignition does not occur in
5 seconds, turn control knob
to OFF, wait 5 minutes to allow gas
to dissipate and repeat lighting
procedure.
 previous next