Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
11
LIGHTING THE ROTISSERIE BURNER:
1. Open grill hood before lighting rotisserie burner.
2. Make sure control knob is in the "OFF" position.
3. Push and turn the control knob to the "HIGH" position.
Press electronic igniter for 3–5 seconds.
4. If ignition does NOT occur in 5 seconds, turn control knob
to "OFF”, wait 5 minutes to allow gas to dissipate and repeat lighting
procedure.
5. To turn off, turn control knob clockwise until it locks in the "OFF"
position.
IMPORTANT: DO NOT use back rotisserie burner when main burners are in use.
MATCH LIGHTING THE ROTISSERIE BURNER:
1. Open grill hood before lighting rotisserie burner.
2. Make sure control knob is in the "OFF" position.
3. Strike and carefully place a match approximately 1/2" (1 to 2 cm) from the lower edge of burner.
4. Push and turn the control knob to the "HIGH" position. Hold a match under burner. The burner should light
within 5 seconds.
5. If the burner does not light, turn the control knob to "OFF" and wait 5 minutes for gas to dissipate and repeat
lighting procedure.
6. If the burner does not light within the first few attempts of match lighting, there is a problem with the gas
supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the problem is
found and corrected. See "Trouble Shooting" section of this manual.
Note: If burner does not light or flame is too low, you may have spider or other insect blockage in burner, or the
flow limiting device has been activated. See "Burner Assembly/Maintenance" under Proper Care and
Maintenance, or "Regulator Resetting Procedure" under Connecting LP Cylinder and Hose/Regulator to
Grill.
LIGHTING THE SEAR BURNER:
1. Open lid before lighting sear burner.
2. Make sure control knob is in the "OFF" position.
3.
Push and turn the control knob to the "HIGH" position. Continue
to push in control knob while pressing electronic igniter for
3–5 seconds.
4. Once burner is lit, continue to push and hold control knob for
30 seconds.
5. If ignition does NOT occur in 5 seconds, turn control knob to "OFF",
wait 5 minutes to allow gas to dissipate and repeat lighting procedure.
6. To turn off, turn control knob clockwise until it locks in the "OFF"
position.