Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Contact 1.800.762.1142 for assistance. Do not return to place of purchase.
page no.
9
Assembly Instructions (continued)
Installing Natural Gas Line
Installation should be done by a qualified service person.
CAUTION: If young children are in the area, a locking valve should be
considered.
Connect Natural Gas Line
Before connecting, be sure that there is no debris
caught in the head of the natural gas line, head of the
grill natural gas line or in the head of the burner and
burner ports.
Connect grill natural gas line to natural gas line.
Disconnect Natural Gas Line
Before disconnecting make sure the natural gas line valve is “OFF”.
Disconnect grill natural gas line from natural gas line.
Operating Instructions
Checking for Leaks
Burner Connections
Burner Connections
1. Make sure the regulator valve and hose connections
are securely fastened to the burner and the gas
line.
If your unit was assembled for you, visually check
the connection between the burner venturi pipe and
orifice. Make sure the burner venturi pipe fits over
the orifice.
WARNING: Failure to inspect this
connection or follow these instructions
could cause a fire or an explosion which
can cause death, serious bodily injury, or
damage to property.
2. Please refer to diagram for proper installation.
(Figure 1 and 2)
3. If the burner pipe does not rest flush to the orifice,
please contact 1.800.762.1142 for assistance.
Tank/Gas Line Connection
1. Make 2-3 oz. of leak solution by mixing one part
liquid dishwashing soap with three parts water.
2. Make sure control knobs are “OFF”. (Figure 3)
3. Turn “ON” natural gas main valve.
4. Spoon leak check solution at all “X” locations
(Figure 4)
a. If any bubbles appear turn natural gas main valve
“OFF”, reconnect and re-test.
b. If you continue to see bubbles after several
attempts, turn natural gas main valve “OFF”
and disconnect natural gas line and contact
1.800.762.1142 for assistance.
c. If no bubbles appear after one minute turn
natural gas main valve “OFF”, wipe away solution
and proceed.
Operating Main Burners
First Use
1. Make sure all labels, packaging and protective films
have been removed from the grill.
2. Remove manufacturing oils before cooking on this
grill for the first time, by operating the grill for at
least 15 minutes on “HIGH” with the lid closed. This
will “heat clean” the internal parts and dissipate
odors.
21
Insert Battery
F
x 1
Figure 1
Valve
Soft Pipe
Connection
NG Gas Valve
with Orifice
Burner
venturi
pipe
Main Burners
Figure 2
Burner
venturi pipe
NG Gas Valve
with Orifice
NG Gas
Connection
Side Burner
Valve
Soft Pipe
Connection
Figure 3
Figure 4