Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
LIGHTING THE MAIN BURNERSUSING ELECTRONIC IGNITION
1. ()pen the lid.
2. Ensure all burner control knobs are in the "OFF' position.
3. Turn on the LP gas by slowly turning the hand wheel on the cylinder valve.
4. Turn one main burner control knob to "High".
5. Depress the electronic ignition button and hold down. You should hear a clicking sound, which shows the
electronic ignition is working.
6. If the burner does not light within 5 seconds, turn the burner control knob to °'OFF'. Wait 5 minutes for the
gas to clear, and repeat the above procedure. Use the Manual directions if it still will not light.
7. When lit, turn the control knob to the desired setting.
8. Your grill is equipped with continuous ignition. Simply turn any other of the main burner control knobs
next to the lit burner to "High" to light, and then to the desired heat setting. They will ignite automatically
once the initial burner is lit. Do not press the electronic ignition button again.
MANUALLY LIGHTING THE MAIN BURNERS WITH THE MATCH LIGHTING STICK
1. ()pen the lid.
2. Ensure all burners are in the °'Off' position.
3. Turn on the LP gas.
4. Place a match in the Match Lighting Stick. This is located on
the left side of the grill cabinet underneath the side burner shelf.
5. Strike the match, and insert into the lighting hole close to the burner.
6. Turn the left burner control knob to "High".
7. If the burner does not light within 5 seconds, turn the burner control
knob to "OFF'. Wait 5 minutes for gas to clear, and try again.
8. When lit, turn the control knob to the desired setting.
9. Then turn the burner control knob of the burner next to it to "High" and continue to do so until all are lit.
LIGHTING THE SIDE BURNER WITH ELECTRONIC IGNITION
1. ()pen the side burner cover
2. Ensure the side burner control knob is in the "OFF' position, as well as any main burners not in use.
3. Turn on the LP gas if it is not already on.
4. Turn the side burner control knob to "High".
5. Depress the electronic ignition button and hold. You should hear a clicking sound, which shows the
electronic ignition is working.
6. If the burner does not light within 5 seconds, turn the burner control knob to °'Off". Wait 5 minutes for the
gas to clear, and repeat the above procedure. Use the Manual directions if it still will not light.
7. When lit, turn the side burner control knob to its desired setting.
LIGHTING THE SIDE BURNER WITH THE MATCH LIGHTING STICK
1. ()pen the side burner cover.
2. Ensure the side burner control knob is in the °'OFF' position, as well
as any main burner not in use.
3. Turn on the LP gas if it is not already on.
4. Strike the match, and place near the top of the burner.
5. Turn the side burner control knob to "High".
6. If the burner does not light within 5 seconds, turn the burner
control knob to °'OFF'. Wait 5 minutes for the gas to clear,
and try again.
7, When lit, turn the side burner control knob to its desired setting.
21