Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
A
p
p
l
y
so
l
u
t
i
on
to
hose regula
t
or
and
the
full length
of
thehose
Apply
so
l
u
t
i
on
to
gas
c
y
l
i
nde
r
va
lv
e
Apply
so
l
u
t
i
on
underneathcontrol
pane
l
where burner and hose
are
connec
t
ed
(Smoker shown on back for clarity
on
l
y
)
Failed test will present
bubb
l
es
as
shown
b
e
l
o
w
.
STEP 4
Attach heat shield (20) to burner box (6)
usingselftappingscrews(B)as
shown.
Tighten all hardware at this time.
STEP 5
Mount body handle (8) to smoker body (1)
using M6*12
(A) and M6Nut
˄
C
˅
.
STEP 6
Insert door handle (7) into smoker
door (2). Secure using M6*25 (F).
Page 10
customer service 1-888-577-9820
Page 5
customer service 1-888-577-9820
SOAPY WATER TEST WARNINGS
&
PROCEDURES
ASSEMBLY
Ɣ
Ɣ
Ɣ
Ɣ
Ɣ
Ɣ
Ɣ
Ɣ
Ɣ
Ɣ
Ɣ
Ɣ
Soapy Water Test MUST be performed each time
gas cylinder is connected to burner/hose or each
time it is used.
Soapy Water Test MUST be performed outdoors in
well ventilated area.
When performing Soapy Water Test keep smoker
away from open fl ames, sparks or lit cigarettes.
Smoker is designed to work with propane gas only.
Only use gas cylinders marked propane with this
unit. This product will NOT operate with natural gas.
Never use an open fl ame to test for gas leaks.
Remove any cookware from smoker.
Make sure regulator and gas cylinder valve to OFF
position.
Prepare soapy water solution: (1) part dish washing
liquid (or more if desired), (3) parts water.
Apply soapy water solution to gas cylinder valve,
regulator and hose length up to burner.
WARNINGS
PREPARATION:
Turn gas cylinder valve ON and watch for bubbles.
DO NOT LEAVE GAS ON MORE THAN 12
SECONDS. If bubbles appear, stop, turn gas
cylinder OFF and retighten fi tting. Repeat test.
AFTER gas cylinder valve has passed Soapy
Water Test, turn gas cylinder valve ON, open
regulator control valve one full turn and check for
bubbles at valve location, along full length of hose
and at burner connection. DO NOT LEAVE GAS
ON MORE THAN 12 SECONDS. If bubbles
appear, stop, turn regulator valve OFF, turn gas
cylinder OFF and retighten the connection that is
leaking gas. If hose is source of leak, STOP, do not
use unit. Hose must be replaced.
When test is complete, and there are no leaks, wait
minimum of 5 minutes for gas fumes to diminish
before lighting cooker.
TESTING GAS VALVE
TESTING REGULATOR AND HOSE:
DURING ANY PORTION OF SOAPY WATER
TEST IF BUBBLES CONTINUE TO APPEAR,
STOP, DO NOT USE UNIT. CONTACT LOCAL
PROPANE DEALER OR MANUFACTURER
CUSTOMER SERVICE 1-888-577-9820.
Note: Use 20LB (9kgs) gas cylinder that has a
protective collar with this unit. Cylinder NOT
included with this unit.