Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
FIG. A
FIG B
COTTER PIN
(Item #4)
BURNER
(Item #3)
Holes in Front
Firewall
Gas Nozzle
Control Valve
Manual
Lighting
Gas Collector
and Electrode
Venturi end of
Burner inserted
over gas nozzle
Top Plate of
Gas Collector
Burner
Burner
Locator
Hole in
Lower
Shoulder
Burner Peg
Cotter Pin - Install
from underneath
Backside of grill
REFERENCE: ELECTRODE GAP
Adjust Tab if greater than 3/16”.
ELECTRODE
3/16”
GAP
MAX.
TAB-GAS
COLLECTOR
STEP 8 - INSTALL BURNERS
(Reference Assembly Diagram page 8)
Repeat above steps for remaining burners.
•Remove plastic covering from Burner(3)
and remove Cotter(4) Pin from Burner Peg
•Fit venturi end of Burner through hole in the inside firewall
(behind Control Panel) and onto Gas Control Valve Nozzle
(FIG. A.) Be careful not to bend or force Gas Collector
•Place other end of burner on lower shoulder of rear
firewall so Burner Peg rests in Burner Locator Hole
as shown ( FIG. B.)
•Using pliers, insert Cotter Pin
through hole in Burner Peg to
secure. This is easier done
from rear, underside of grill.
9