Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
8
1. Open the Hood.
2. Push LEFT Burner Control Knob on Control Panel in and turn 90 degrees counterclockwise to the High position.
3. Push the Igniter Button in repeatedly until the Burner is lit (Fig. 2). Listen for the click indicating spark ignition, and
look to make sure the Burner is lit.
4. From the “Off” position, light the other Right hand burner. Your grill has a Crossover Ignition System that allows the
Right burner to light from the Left. Confirm the Left burner is lit before attempting to light the Right burner.
If a Burner goes out during operation, turn all Control Knobs to the “Off” position. Open Hood and wait five minutes
before attempting to relight the grill to allow any accumulated gas to dissipate.
If Burners fail to light after three to four attempts, turn all Control Knobs to the “Off” position and allow any accumu-
lated gas to dissipate. Check for igniter spark by pushing igniter button and looking at the igniter tip. If no spark, adjust
gap between electrode tip and burner to 3/16” (Fig. 3). If still no spark, see Troubleshooting Section.
Wait five minutes; then repeat the lighting procedures.
The Burner can also be lit manually, see Manual Lighting of the Grill.
Should you notice that your Burner(s) are getting hard to light or the flame is not as hot as it once was, refer to the
“How to Clean your Burners” to remove any possible obstructions.
Igniter Button
Left Main Burner
Control Knob in
OFF position
3/16” gap
If no spark, adjust gap between
electrode tip and burner to 3/16”
Lighting the Grill Using the Pulse-Spark Ignitor
Manually Lighting the Grill
LEFT Burner
Match
1. Open the Hood.
2. IMPORTANT:
Make sure Control Knobs are turned “Off.”
3. While holding a lit match near the LEFT burner, push LEFT
Burner Control Knob in and turn 90 degrees counterclock-
wise to the High position. (Fig. 4)
Step 3 may also be accomplished by inserting the lit match
through one of the holes in the bottom of the bowl near the
LEFT burner.
4. Your grill has a Crossover Ignition System that allows the
Right burner to light from the Left. Confirm the Left burner is
lit before attempting to light the Right burner.
If a Burner goes out during operation, turn all Control Knobs to the
“Off” position. Open Hood and wait five minutes before attempting
to relight the grill to allow any accumulated gas to dissipate.
Fig. 2
Fig. 3
Fig. 4