Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Getting Started
10
Installing your BBQ Guru temperature control system
The BBQ Guru temperature control system is normally
installed on the rear surface of the Caldera Del Fuego
Tallboy. Start by inserting the nozzle of the Turbo
Draft Fan into the Inducer tube of the Firebox
Housing. Attach the Controller Mounting Bracket to
the Tallboy. Attach the BBQ Guru controller to its
bracket and connect the cables from the Turbo Draft
Fan and from the Temperature Probes.
Pass the Temperature Probes through the Silicone
Gasket from the outside into the Cooking Chamber.
Pierce the major cooking item with the Meat Probe and
clip the Pit Probe to it where it will not contact the
meat.
Other arrangements of the equipment are possible. This one is popular, practical and a good
starting point for a new user. You may elect to mount the provided bracket, with screws, to a
short wooden board as a base. Then place your control on top of the cooker at a convenient eye
level.
Some users prefer to rig the control equipment
using the Inducer tube on the front of the Firebox
and one of the three Silicone Grommet locations in
the Door of the Cooking Chamber.
Experiment with different setups and find the one
that works easiest for your mission. No two cooks
ever agreed upon the one ‘right’ way to arrange a
working kitchen! Arrange your BBQ Guru to make
use of your Caldera Del Fuego Tallboy
comfortable for you.