Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
6
19. To mount the tool holder brackets to the front of
the cart it will be necessary to drill four holes in the
front panel of the cart. (Recommended hole size is
9/32" diameter.) The tool bracket holders may be
used to locate hole positions by placing the bracket
against the front panel and marking the hole loca-
tions onto the front panel. The top tool holder
bracket should be positioned equally from each
side of the cart and even with the top edge of the
front panel. The bottom tool holder bracket should
be positioned equally from each side of the cart
with the top of the bracket approximately six inches
up from the bottom. See figure 13.
20. Press the protective edging strips over the top
edge of both tool holder brackets. Mount the tool
holder brackets on the inside of the front panel of
the cart using four 1/4" x 1/2" hex bolts, 1/4" lock
washers and 1/4" hex nuts. See figure 13.
FIGURE 13
1/4" x 1/2"
HEX BOLT
1/4" LOCK
WASHER
1/4" HEX NUT
TOOL HOLDER
BRACKET
21. Place the tailgate down into the tailgate guides so
that the holes in bottom lip of tailgate fit over
heads of slotted head screws in bottom of cart.
This completes the assembly of your cart.