Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
5
13. Lower the cart assembly to rest upside down on its
top flanges, with wheel support up. See figure 11.
FIGURE 9
LATCH LOCK
SUB-ASSEMBLY
1/4" x 5/8"
HEX BOLT
1/4" LOCK
WASHER
1/4" HEX NUT
DRAW BAR
TONGUE
14. Assemble latch lock subassembly to drawbar
tongue using two 1/4" x 5/8" long hex bolts, lock
washers and hex nuts. Tighten. See figure 9.
16. Assemble axle and drawbar tongue to wheel sup-
port keeping the open side of tongue facing away
from cart. Make sure the latch lock snaps over the
top of latch stand bracket. Secure axle to wheel
support using two 1/4" x 1-3/4" hex bolts, lock
washers and hex nuts. See figure 11.
FIGURE 11
1/4" x 1-3/4"
HEX BOLT
1/4" HEX NUT
1/4" LOCK
WASHER
AXLE
DRAW BAR
TONGUE
WHEEL
SUPPORT
TONGUE
3/8" x 1"
HEX BOLT
3/8" LOCK
WASHER
3/8" HEX
NUT
15. Assemble hitch bracket to drawbar tongue, using
two 3/8" x 1" hex bolts, 3/8" lock washers and 3/8"
hex nuts. See figure 10.
17. Assemble a spacer tube, a 1" flat washer, a wheel
with the valve stem facing out, and another 1" flat
washer onto the axle as shown in figure 12. Se-
cure with a cotter pin and spread ends so that hub
cap can fit over the cotter pin . Assemble the hub
cap by pressing it onto the flat washer. Repeat for
other end of axle.
FIGURE 10
FIGURE 12
COTTER PIN
SPACER TUBE
WHEEL
HUB CAP
1" FLAT
WASHER
1" FLAT
WASHER
AXLE
18. Turn cart over so that it rests right side up on its
wheels.