Zenoah EDG2300 Gas Grill User Manual


  Open as PDF
of 24
 
14
• Before cleaning, inspecting or repairing
your unit, make sure that engine has
stopped and is cool. Disconnect the
spark plug terminal to avoid accidental
engine starts.
■ DAILY INSPECTION
•Remove grass or dust, from the entire
body.
• Check that all nuts and screws are
securely tightened, and no parts are
missing.
• Check for leakage of fuel.
WARNING
■ INSPECTION EVERY 25 HOURS
• Remove the air cleaner element from the
carburetor air intake cover and wash in
warm, soapy water. Dry completely before
installing.
Maintenance
■ MAINTENANCE CHART
every every every
25 50 100
system/compornent procedure before hours hours hours note
use after after after
fuel leaks, fuel spillage wipe out ✔
fuel tank, air filter, fuel filter inspect/clean ✔✔ replace, if necessary
see
■ADJUSTING
replace carburetor
idle adjusting screw ✔
IDLING SPEED (p.13)
if necessary
clean and readjust
GAP: .025in(0.6~0.7mm)
spark plug ✔
plug gap replace, if necessary
cylinder fins, intake air cooling vent clean ✔
muffler, spark arrester, cylinder exhaust port
clean ✔
throttle lever, ignition switch check operation ✔
screws/nuts/bolts tighten/replace ✔✔not adjusting screws
Maintenance, replacement, or repair of the emission control device and systems may be
performed by any non-road engine repair establishment or individual.
Cleaner element
Cleaner cover
 previous next