Weber SILVERC GENESIS Gas Grill Gas Grill User Manual


 
B-1
Assemble wheel frame
You will need: axle rod, two wheel hubcaps, two
wheels, wheel frame, hammer and a block of wood.
Place one end of the axle rod on the block of wood (or
other protected surface). Tap one hubcap onto the end
of the axle rod. Slide one wheel onto the axle, WEBER
name facing out. Next, slide the other end of the axle
rod through the wheel frame. Add the other wheel,
WEBER name side facing out. Tap the hubcap onto
the axle rod to complete the axle.
Assemble frame
You will need: left frame, right frame, two 1/2 inch
bolts, two nylon washers and a 7/16 inch or adjustable
wrench.
Note - Work on carpeted area (on grass or one of the
boxes) to protect the finish during frame assembly.
Lay the leg frame pieces as shown so the leg tabs
point up.
1) Connect the two frame pieces with the tabs inside
of the frame.
2) Slip washers on bolts, then insert bolts as shown
and tighten. (If you try to insert a bolt and there is
no hole, you have the left frame turned the wrong
way. Turn the left frame around.)
Assembly Instructions
W
E
B
E
R
W
E
B
E
R
(1)
(2)
B069.a