Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Buy Weber Grill Parts. It couldn't be easier. Find your Weber parts here.
30
WWW.WEBER.COM
®
WEBER
®
SPIDER /INSECT SCREENS
Your Weber
®
gas barbecue, as well as any outdoor gas appliance, is a target for spiders
and other insects. They can nest in the venturi section (1) of the burner tubes. This
blocks the normal gas fl ow, and can cause the gas to fl ow back out of the combustion
air opening. This could result in a fi re in and around the combustion air openings, under
the control panel, causing serious damage to your barbecue.
The burner tube combustion air opening is fi tted with a stainless steel screen (2) to
prevent spiders and other insects access to the burner tubes through the combustion air
openings.
We recommend that you inspect the Spider/Insect screens at least once a year.
(See Section “Annual Maintenance”.) Also inspect and clean the the Spider/Insect
screens if any of the following symptoms should ever occur:
1) The smell of gas in conjunction with the burner fl ames appearing yellow and lazy.
2) Barbecue does not reach temperature.
3) Barbecue heats unevenly.
4) One or more of the burners do not ignite.
ƽ DANGER
Failure to correct the above mentioned symptoms may result
in a fi re, which can cause serious bodily injury or death, and
cause damage to property.
1
2
MAIN BURNER CLEANING PROCEDURE
Turn off the gas supply.
Remove the manifold (See “Replace Main Burners”).
Look inside each burner with a fl ashlight.
Clean the inside of the burners with a wire (a straightened-out coat hanger will work).
Check and clean the air shutter opening at the ends of the burners. Check and clean
the valve orifi ces at the base of the valves. Use a Steel bristle brush to clean outside of
burners. This is to make sure all the burner ports are fully open.
ƽ CAUTION: Do not enlarge the burner ports when cleaning.
REPLACE MAIN BURNERS
1) Your Summit
®
gas grill must be off and cool.
2) Turn gas off at source.
3) Disconnect gas supply.
4) Remove cooking grates.
5) Remove smoker box.
6) Remove Flavorizer
®
bars.
REMOVE CONTROL PANEL
7) Part required: Phillips Screwdriver.
a) Remove the burner control knobs.
b) Remove the two screws that secure the control
panel to the frame.
c) Remove the control panel. Tilt panel forward and
lift up and away from grill. Completely remove
the control panel from the cooking box assembly
exposing the valves, burners, igniter, and manifold.
a
b
c
MAINTENANCE