Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Buy Weber Grill Parts. It couldn't be easier. Find your Weber parts here.
Step 5 (Case 2)
Connect the QCC1 hose and regulator assembly to LP tank
ƽWARNING: Make sure that the LP cylinder valve is closed. Close by turning valve
clockwise.
If you have a model with a side burner, route the hose through the left hole in the support panel.
The hose and regulator are connected in the following manner:
1. Remove the plastic dust cover from the valve.
2. Screw the regulator coupling onto the tank valve, clockwise, or to
the right.
Hand-tighten only.
Note: This is a new type
of connection. It tightens
clockwise and will not allow
gas to flow unless the
connection is tight.
The connection requires
tightening by hand only.
ƽWARNING: Do not use a wrench to tighten the
connection. Using a wrench could damage the
regulator coupling and could cause a leak.
3. Check for leaks by wetting the fitting with the soap and
water solution and watching for bubbles. If bubbles form,
or if a bubble grows, there is a leak.
If there is a leak, turn off the gas and tighten the fitting. Turn
the gas back on and recheck with the soap and water solution.
Screw coupling clockwise