Weber E/S 470 Gas Grill User Manual


  Open as PDF
of 92
 
33
WWW.WEBER.COM
®
33
SEAR BURNER TROUBLESHOOTING
OPERATING THE HANDLE LIGHT
The Weber Grill Out™ Handle Light has a built-in “Tilt Sensor.” With the power button (a)
activated, the light will come on when the grill lid is open. The light will turn off when the lid
is closed. For daytime use, deactivate the sensor by pressing power button (a).
HANDLE LIGHT TROUBLESHOOTING
PROBLEM CHECK CURE
Weber Grill Out
™
Handle
Light does not light.
Are the batteries old? Replace batteries.
Are the batteries installed correctly? See assembly illustration.
Is the lid in the up position with the power button ON? Light will activate when lid is open.
Is the Weber Grill Out
™
Handle Light activated? Press the power button.
Is the Weber Grill Out
™
Handle Light positioned correctly on the handle? Adjust position (See assembly illustration).
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web
site. Log onto www.weber.com
®
.
PROBLEM CHECK CURE
Burners burn with a yellow or orange
flame, in conjunction with the smell
of gas (This is normal for the burner
lighting tube).
Inspect Spider/Insect Screens for possible
obstructions. (Blockage of holes.)
Clean Spider/Insect Screens. (See Section “Annual Maintenance”)
Sear Station burner does not light. Did you ignite the two adjacent main burners
(See Sear Station
™
burner lighting instructions
for safe lighting procedure)
Verify adjacent main burner ignition by visual inspection of a flame.
ƽ WARNING: If ignition does not occur in 5 seconds, turn burner control
OFF, wait 5 minutes to let the gas clear before you try again
Does Burner light with a match? If you can light Burner with a match, then check the Crossover
®
Channel on the sear
burner. (See Maintenance for burner removal and cleaning procedure.)
Does the igniter work (Do you see a spark
when you repeatedly use the snap igniter?
Try manually lighting the burner (refer to “Lighting the Rotisserie Burner”). Call
customer service.
General Symptoms:
Burner does not light. -or- Burner has
a small flickering flame
The excess flow safety device, which is part of
the barbecue to cylinder connection, may have
activated.
To reset the excess flow safety device turn all burner control knobs and the cylinder
valve to “OFF”. Disconnect the regulator from the cylinder. Turn burner control knobs
to “START/HI”. Wait at least 1 minute. Turn burner control knobs to “OFF”. Reconnect
the regulator to the cylinder. Turn cylinder valve on slowly. Refer to “Lighting
Instructions”.
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web
site. Log onto www.weber.com
®
.
ƽ ATTENTION: This product has been safety tested and is only certified for use in a specific country. Refer to country
designation located on outer carton.
These parts may be gas carrying or gas burning components. Please contact Weber-Stephen Products Co., Customer Service Department for genuine Weber-
Stephen Products Co. replacement part(s) information.
ƽ WARNING: Do not attempt to make any repair to gas carrying or gas burning components without contacting Weber-Stephen
Products Co., Customer Service Department. Your actions, if you fail to follow this product Warning, may cause a fire or an
explosion resulting in serious personal injury or death and damage to property.
 previous next