Weber D201_LP.c Gas Grill User Manual


 
E-2
Maintenance
Replacing Main Burners
1) Your Weber
®
gas barbecue must be OFF and cool.
2) Turn gas OFF at source.
3) To remove control panel: take off the burner control
knobs. Remove the screws holding the control panel in
place. Lift off the control panel.
4) Unhook the manifold bracket(1) and unscrew the two
wing nuts(2) that hold the manifold to the cooking box.
Pull the manifold and valve assembly out of the
burners and carefully set it down.
5) Slide the burner assembly out from under the guide
screw and washer(1) in the corners of the cooking box.
6) Lift and twist the burner assembly slightly, to separate
the crossover tube(1) from the burners. Remove the
burners from the cooking box.
(2)
(1)
(1)
7) To reinstall the burners, reverse 3) through 7).
ƽ CAUTION: The burner openings(1) must be
positioned properly over the valve orifices(2).
Check proper assembly before fastening manifold in place.
(1)
ƽ WARNING: After reinstalling the gas lines, they
should be leak checked with a soap and water
solution before using the barbecue. (See Step:
Check for gas leaks.)
(2)
(1)
(1) (2)
Crossover
®
Ignition System Operations
If the Crossover
®
ignition system fails to ignite the Left
burner, light the Left burner with a match. If the Left
burner lights with a match, then check the Crossover
®
ignition system.
Check that both the white(1) and black(2) ignition wires
are attached properly.
Check that the Crossover
®
ignition button pushes
the igniter (button) down, and returns to the up
position.
If the Crossover
®
ignition system still fails to light,
Contact the Customer Service Representative in your
region using the contact information sheet provided
with your manual.