Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Buy Weber Grill Parts. It couldn't be easier. Find your Weber parts here.
C-3
To raise swing-up work surface: Lift table all the way
up and slide it to the left, then lower table until you feel
it lock in the up position.
To lower swing-up work surface: Lift table up until it
disengages and slide it to the right. Then lower it all
the way down so that the locking pin on the right side
of the table fits into the locking bracket on the leg,
which will secure the table in the down position.
Do not use the swing-up work surface as a cutting
board.
Install the left end trim piece and swing-up work
surface
You will need: End trim piece, swing-up work surface,
swing-up work surface rod, two 1/2 inch bolts, two
nylon washers and a wrench
1.) Start the left end trim piece into the frame as
shown, do not push the trim piece in all of the
way and do not add bolts yet.
2.) Slide the swing-up work surface rod through the
holes at the top of the swing-up work surface.
3.) Insert one end of the swing-up work surface rod
into the hole in the frame.