Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Buy Weber Grill Parts. It couldn't be easier. Find your Weber parts here.
14
maIN bUrNEr IGNITIoN & USaGE
2
6
7
4
5
3
1
2
4
5
APAGADO
OFF
ARRETE
1
2
4
5
APAGADO
OFF
ARRETE
1
MAIN BURNER IGNITION
Summary lighting instructions are inside the left hand cabinet door.
m DANGER
Failure to open the lid while igniting the barbecue’s burners,
or not waiting 5 minutes to allow the gas to clear if the
barbecue does not light, may result in an explosive flare-up
which can cause serious bodily injury or death.
Crossover
®
Ignition System
Note: The Crossover® Ignition System ignites BURNER 1 with a spark from the igniter
electrode inside the Gas Catcher™ ignition chamber. You generate the energy for the
spark by pushing the electronic ignition button. You will hear it sparking.
m WARNING: Check hose before each use of barbecue for
nicks, cracking, abrasions or cuts. If the hose is found to
be damaged in any way, do not use the barbecue. Replace
using only Weber
®
authorized replacement hose. Contact
the Customer Service Representative in your area using the
contact information on our web site.
Log onto www.weber.com
®
.
◆
A) Open the lid (1).
B) Make sure all burner control knobs are turned OFF (2). (Push control knob down
and turn clockwise to ensure that it is in the OFF position.)
C) Turn the gas supply valve on (3).
m WARNING: Do not lean over the open barbecue. Keep your
face and body at least one foot away from the matchlight
hole when lighting the barbecue.
D) Push BURNER 1 control knob down and turn to START/HI (4).
E) Push and hold the electronic ignition button. You will hear it sparking (5).
F) Check that the burner is lit by looking through the matchlight hole on the front of the
cooking box. You should see a flame (6).
m WARNING: If the burner does not light in five seconds, turn
the Burner 1 control knob to OFF and wait five minutes to
let the gas clear before you try again or try to light with a
match.
G) After BURNER 1 is lit you can turn on BURNER 2 (and BURNER 3) (7).
Note - Always light BURNER 1 first. The other burners ignite from BURNER 1.
◆
TO EXTINGUISH
Push down and turn each burner control knob clockwise to the OFF position. Turn gas
supply OFF at the source.
◆
The grill illustrated may
have slight differences
than the model purchased.