Weber 450 Gas Grill User Manual


  Open as PDF
of 20
 
LIGHTING
EACH HEAT ZONE OPERATES INDEPENDENTLY.
Summary lighting instructions are on the control panel.
High Medium Low Off
Crossover Ignition System
DANGER
Failure to open lid while igniting the
barbecue, or not waiting 5 minutes to allow
the gas to clear if the barbecue does not light,
may result in an explosive flame-up which
can cause serious bodily injury or death.
Note - The Crossover Ignition System ignites the Left
burner of each heat zone with a spark from the igniter
electrode inside the Gas Catcher Ignition Chamber. You
generate the energy for the spark by pushing the
Crossover Ignition Button until it clicks.
WARNING: Check hose before each use of barbecue
for nicks, cracking, abrasions or cuts. If the hose is
found to be damaged in any way, do not use the
barbecue. Contact your dealer.
WARNING:The storage space under the cooking
module is intended for storage of nonflammable
items only.
Crossover Ignition System
2
Figure 1
1) Open the lid. Figure 1.
2) Check that the fuel scale reads more than "E".
Note - E = empty; F = full.
3) Make sure all burner control knobs are OFF. (Push
each burner control knob down and turn clockwise.)
WARNING: The burner control knobs must be in the
OFF position before turning on the LP tank valve. If
they are not in the OFF position, when you turn on
the LP tank valve, the excess flow control will
activate, limiting the flow of gas from the LP tank. If
this should occur, turn OFF the LP tank valve and
burner control knobs and start over.
DANGER
When the excess flow control is activated,
a small amount of gas is still flowing to the
burners. After turning OFF the tank and
burner control knobs, wait at least 5 minutes
for the gas to clear before attempting to light
the barbecue. Failure to do so may result in
an explosive flame-up which can cause
serious bodily injury or death.
4) Turn the tank on by turning the tank valve
counterclockwise.
WARNING: Do not lean over open barbecue. Keep
your face and body at least one foot away from the
matchlight hole when lighting the barbecue.
Select Heat Zone.
5)
6)
7)
8)
Push LEFT burner control knob down and turn to
START/HI.
Push the Crossover Ignition Button several times, so
it clicks each time.
Check that the burner is lit by looking through the
matchlight hole above the burner control knob.
WARNING: If the burner does not light, turn the LEFT
burner control knob to OFF and wait 5 minutes to let
the gas clear before you try again or try to light with
a match.
9) After the LEFT burner is lit you can turn on the
RIGHT burner.
Note - Always light the LEFT burner firsL The RIGHT
burner ignites from the LEFT burner.
TO EXTINGUISH
Turn gas supply OFF at the source, then push down
and turn each burner control knob clockwise to OFF.
 previous next