Weber 42373 Gas Grill User Manual


 
66
GAS INSTRUCTIONS
Remove the Front Panel by sliding the panel up and out of
the slots.
Check:
1) Gas line-to-manifold connections.
ƽ WARNING: If there is a leak at connection (1),
retighten the fi tting with a wrench and recheck for
leaks with soap and water solution.
If a leak persists after re-tightening the fi tting, turn
OFF the gas. DO NOT OPERATE THE GRILL. Contact
the Customer Service Representative in your region
using the contact information sheet provided with your
manual.
2) Valves to manifold connections.
ƽ WARNING: If there is a leak at connections (2), turn
OFF the gas. DO NOT OPERATE THE GRILL. Contact
the Customer Service Representative in your region
using the contact information sheet provided with your
manual.
When leak checks are complete, turn gas supply OFF at
the source and rinse connections with water.
(1)
(2)
Reinstall control panel
Parts required: control panel, screws, and burner control
knobs.
Place the control panel back onto the control panel brackets
on either side of the front of the cooking box.
Line up screws with screw holes on both the control panel
and control panel brackets. Tighten screws.
Reinstall burner control knobs & igniter wires (if necessary).
Place corresponding control knobs down onto the valve
stems. From the underside of the control panel, replace the
two wires (1, 2) of each igniter.
(1)
(2)
-
+
-
+
2
1
1 = White Tab with Black Wire
2 = Yellow Tab with Black Wire