Weber 41061 Gas Grill User Manual


  Open as PDF
of 32
 
10
PROBLEM CHECK CURE
Burners burn with a yellow or orange flame, in
conjunction with the smell of gas.
Inspect Weber
®
Insect/Spider screen for possible obstructions.
(Blockage of holes.)
Clean Weber
®
Insect / Spider screen. (See Section
“Annual Maintenance”)
Burner does not light, or flame is low in
HIGH position.
Is LP cylinder fuel low or empty? Does the burner light with a
match?
Replace propane cylinder. If you can light the burner with a match, then check
the ignition system.
Experiencing flare-ups:
ƽ CAUTION: Do not line the bottom tray with
aluminum foil.
Are you preheating grill in the prescribed manner? Is the cooking
grate heavily coated with burned-on grease?
Burner on high for 10 minutes for preheating.Clean thoroughly. (See Section
“Cleaning”) Clean bottom tray.
Burner flame pattern is erratic. Flame is low
when burner is on HIGH. Flames do not run
the whole length of the burner tube.
Is the bottom tray “dirty” and not allowing grease to flow into catch
pan? Is the burner clean?
Clean burner. (See Section “Annual Maintenance”.)
Inside of lid appears to be “peeling.”
(Resembles paint peeling.)
The lid is cast aluminum, not paint. It cannot “peel”. What you are
seeing is baked on grease that has turned to carbon and is flaking
off. THIS IS NOT A DEFECT.
Clean thoroughly. (See Section “Cleaning”.)
Burner does not light when igniter button is
pushed.
Does burner light with a match? If you can light burner with a match, refer to “IGNITION SYSTEMS
OPERATION”.
Burner flame does not ignite completely
around the burner tube.
Are the burner ports clean and fully open? Clean burner. (See Section “Annual Maintenance”.) Use a small paper clip to
unclog any dirty ports.
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your region using the contact information on our web site. Log onto
www.weber.com
®
.
TROUBLESHOOTING
 previous next