Weber 39950 Charcoal Grill User Manual


  Open as PDF
of 12
 
9
(4)
(5)
(1)
(2)
(3)
INSTALL WIRE LID HOLDER ASSEMBLY
You will need: Wire lid holder assembly and a 1/2 inch open-end or an adjustable wrench.
Remove 5/16-18 hex nut (1), 5/16 inch lock washer (2) and 7/8 inch aluminum washer (3) from each
end of wire lid holder. Finger tighten remaining 5/16-18 hex nut (4).
Note - Bushings (5) should roll freely on wire lid holder.
Insert ends of wire lid holder through frame assembly and bowl on outside of wheel legs. Place 7/8
inch aluminum washer (3), 5/16 inch lock washer (2) then 5/16-18 hex nut (1) on each end of the
wire lid holder and tighten.
INSTALL TUCK-AWAY FRAME SUPPORT
Swing Tuck-Away frame support up and set wire lid holder, with tabs centered (1), into slots in frame
support.
8
9
(1)
ASSEMBLY
 previous next