Weber 2000 Gas Grill User Manual


  Open as PDF
of 32
 
Step 19
Complete accessory installation
You will need: work table, two accessory trays, Warm-Up
Basket, warming rack, thermometer, three tubing plugs and
a hammer.
Insert one end of the Weber Warm-Up Basket into the hole
in the right end of the lid and the other end into the slot in
the left end of the lid. Figure 27 (a).
Set the work tables onto the left and right side rails.
Figure 27 (b).
Set the accessory trays between the two frame connectors.
Figure 27 (c).
Set the warming rack into the slots at the rear of the
cooking box. Figure 27 (d).
Insert the thermometer into its holder. Figure 27 (e).
Insert tubing plugs into the ends of the frame. To fully seat
the plugs, you may have to tap them lightly with a hammer.
Figure 27 (f).
Figure 27
(a)
(d)
(e)
(f)
(b)
(c)
20
Position slide bar assembly on the outside of the caster
frame. Put a nylon washer on each 1 3/4 inch screw, insert
screws through frame and slide bar assembly and add nylon
washers and hex nuts. Tighten nuts using a screwdriver and
pliers. Figure 25.
Figure 25
View from front
of barbecue
Notch to the front
Slide bar
To lower table: Pull support rod up to disengage slide lock,
and lower table. To raise table, lift table up and engage slide
in locked position. Figure 26.
View from rear
of barbecue
Support rod
Locked position
Unlocked position
Figure 26
Slide
ƽCAUTION: To keep the barbecue stationary, the tabs
on the locking casters should be in the down position.
 previous next