Viking VGIQ55404REL Gas Grill User Manual


 
11
Prior to turning on the gas, inspect the gas supply tubing or hose. Look
for evidence of abrasion, cuts, wear and tear, or other damage which
could require replacement prior to use. Make sure all burner control knobs
are off. Do not attempt to light the burners if the smell of gas is present.
Check the connection with a soap and water solution after attaching the
hose. Make sure there is gas in the tank and the tank is upright.
Briquette Trays Proper Installation
Note: The flash tube must be accessible through the plates. If the flash tube is not
accessible, the trays are not properly installed.
Using Grill with Outdoor Approved Hoods
Outdoor approved hood models should be installed in a covered yet non-
enclosed (well ventilated) area. Outdoor hoods aid greatly in smoke and odor
removal, but should not be expected to eliminate entirely. They should also
be protected from natural elements (such as rain) as much as possible.
ALWAYS turn the outdoor hood to the “HIGH” position before lighting the
grill.
Keep the grill canopy closed as much as possible when cooking so smoke is
exhausted out the back of the grill. This allows optimum performance of the
hood.
During breezy conditions, the performance of the outdoor hood may be
compromised.
Before Lighting Grill
Getting Started
10
Features
Getting Started
4
3
6
7
8
9
13
14
15
10
1
2
5
11
12
1. Electronic ignition
2. Rotisserie control knob
3. 9V battery—behind control
panel (100 Series models)
4. Grill burner control knobs
5. Pull out drip tray (500 Series)
6. Interior light switch (300 and
500 Series)
7. Porcelain grids w/ceramic
briquette trays underneath
(Stainless Steel grids on 300
Series)
8. Smoker box (500 Series only)
9. Rotisserie bracket
10. Rotisserie motor
11. Spit rod w/forks
12. Warming rack (if applicable)
13. Infrared rotisserie burner (if
applicable)
14. Interior lights
(300 and 500 Series)
15. Canopy
Note: Control locations will vary according to model.
CAUTION
Wait at least five minutes before relighting a hot grill to allow any
accumulated gas to dissipate. Keep a spray bottle of soapy water near
the gas supply valve and check the connections for gas leaks before
each use.
1
2
Place the tabs on rear of stainless steel
briquette trays into slots on rear panel.
Lower stainless steel trays so the
front tabs rest on the grill frame.