Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
13
Lighting Grill Burners with Flash Tubes
Place the lit match through the grid next to the flash tube of the
burner being lit. Keep your face as far away from the grill as possible.
Make sure the match is adjacent to the flash tube. Push and turn the
control knob until the “HIGH” position on the knob aligns with the
indicator line on the control panel. Make sure you are turning the
control knob that corresponds with the burner being lit. If the burner
does not light in 4 seconds, turn the knob to “OFF,” wait five
minutes, and try again. If the burner will not light after several
attempts, see the Troubleshooting section.
Lighting TruSear™ Infrared Burner (If Applicable)
Before lighting the burner, remove the stainless steel cover. Push in
and turn the TruSear™ infrared control knob until the “HIGH” position
on the knob aligns with the indicator line on the control panel. Once
lit, turn the control knob to the desired setting. If the burner does not
light within 4 seconds, release and turn the control knob to “OFF.”
Wait 5 minutes for any accumulated gas to dissipate and try again.
After several failed attempts, the burner may be lit by turning the
control knob to “HIGH” and dropping a match on the face of the
burner. If the burner does not immediately ignite, turn the knob to
“OFF”, wait 5 minutes and try again.
Lighting the Grill Burners (300 and 500 Series Models)
Make sure the unit is plugged into a properly grounded receptacle.
Turn the appropriate control knob counterclockwise to any position.
This control is both a gas valve and an electric switch. Burners will
ignite at any “ON” position with the automatic re-ignition system. If
the flame goes out for any reason, the burners will automatically
re-ignite if the gas is still flowing. When gas is permitted to flow to the
burners, the electric igniters start sparking. On all surface igniters you
should hear a clicking sound. If you do not, turn off the control and
check that the unit is plugged in and that the fuse or circuit breaker is
not blown or tripped.
Within a few moments, enough gas will have traveled to the burner to
be able to light. When the burner lights, turn the burner control to any
position to adjust the flame size. If the burner does not light in four
seconds, turn the knob to “OFF” and wait 5 minutes before trying
again. This will allow accumulated gas to dissipate. After several failed
attempts the burner can be lit with a paper book match using the flash
tubes.
Lighting Grill
Operation
12
100 Series Models
When lighting a burner, always pay close attention to what you
are doing. Be certain you are pressing the battery ignition button
corresponding to the burner you are lighting.
Lighting Grill Burners
Open the hood or remove covers. Push and turn the control knob until
the “HIGH” position on the knob aligns with the indicator line on the
control panel. Press the electronic ignition button corresponding to
the burner being lit. You will hear a clicking sound. Turn the control
knob to the desired setting. If the burner does not light in 4
seconds, turn the knob to “OFF” and wait 5 minutes before trying
again. This will allow accumulated gas to dissipate. After several failed
attempts the burner can be lit with a paper book match using the flash
tubes. If you have just attempted to light the burner with the ignitor,
allow 5 minutes for any accumulated gas to dissipate.
Lighting Grill
Operation
Electronic
ignitor
NOTE: Control locations
will vary according to model.
Rotisserie
control knob
Grill burner
control knob
Flash tubeFlash tubeFlash tube