Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Safety Upgrade Instructions
Page 11
Figure 18. Right cross log
5. Place the right front log
(stamped “R” underneath) over the
other logs. Locate it over the peg in
the front log and into the channel
in the rear log (See figure 18).
• Without replacing the glass window, fit the fascia. Check for smooth operation of the
ignitor lever. If the ignitor lever contacts the fascia at its lowest depressed position,
adjustment is required. Insert a screwdriver between the firebox and fascia (through
the void space where the glass window would be) and loosen the set screw halfway up
on the ignitor bar. Adjust the ignitor lever up to almost the top of the opening in the
fascia and tighten set screw. Re-check operation of ignitor lever to ensure no contact
with fascia in the upper released or lower depressed position. Remove fascia again.
• With the glass window still removed, re-connect the gas supply to the heater and carry
out a leak test on all of the gas connections up to the control valve. Next light the
fireplace and leak test between the control valve and the burners. Shut off the
fireplace.
• Replace the glass window as in the Installation and Owner’s manual. Ensure window
is completely down in lower support track and all three upper buckles secured.
• Fit the Fascia and ignition bar knob.
• Conduct full operational checks as in the Installation and Owner’s manual.