Ultratec LSX Low smoke converter Smoker User Manual


  Open as PDF
of 7
 
www.ultratecfx.com
6
If LSX will not Power Up Check Power source and connections
Green ‘LED’ is not illuminated & Red ‘LED’ is
illuminated
Low Pressure Switch has tripped, allow for Auto Reset
Low Pressure Switch will not Auto Rest. Red ‘LED’
remains illuminated
Low Refridgerant Charge (Contact Local Dealer)
Fog will not remain on ground 1. Ensure the use of Ultratec Special Effects Fluid
2. Check digital temperature display reading for coil
temperature
3. Check Green and Red ‘LED’ see above
Green ‘LED’ goes out when unit is operating and
Red ‘LED’ doesn’t illuminate
Check Power Source for sufcient voltage. Do NOT use
extension cords.
Condensation on oor / Floor seems slippery 4. Too much fog going through LSX
5. Fog machine nozzel is too close to LSX
6. Reduce fog output, or duration
Before Requesting Service
Recommended Fluids
Molecular Fog Fluid: A faster dissipation versus the Director’s Choice Fog Fluid. This thick, clean, white fog is an
optimal solution for a dense low-lying fog effect when chilled with the LSG or LSX machines.
Maintenance Fluid
EZ Kleen Preventative Maintenance Fluid: Using EZ Kleen preventative maintenance uid on a regular basis ensures
longer life for the heat exchanger in Ultratec fog machines by reducing blockage.
All of our Fog Fluids are water based. Damage will occur if Haze Fluid is used.
 previous