Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
CAUTION
If burner does not light, turn knobs to , wait 5
minutes, and try again. If the burner does not ignite with
the valve open, gas will continue to flow out of the burner
and could accidently ignite with risk of injury.
OFF
Burner Flame Check
• Remove cooking grate and VapoRISER Bar. Light burner,
rotate knobs from (High) to (Low). You should see a
smaller flame in Low position than seen on High. Always check
flame prior to each use. Perform flame check on sideburner. If
only low flame is seen refer to "Sudden drop or low flame" in
the .Troubleshooting Section
High
Low
Turning Grill Off
Ignitor Check
Valve Check
Hose Check
General Grill Cleaning
• Turn all knobs to position. Turn LP tank off by turning
hand-wheel clockwise to a full stop.
Press ignitor button rapidly. "Click"
should be heard and spark seen each time between collector
box or burner and electrodes. See if no click
or spark.
. Knobs lock in position. To check valves, first
push in knobs and release, knobs should spring back. If knobs
do not spring back, replace valve assembly before using grill.
Turn knobs to position then turn back to position.
Valves should turn smoothly.
Before each use, check to see if hoses are cut or worn.
Replace damaged hoses before using grill. Use only
valve/hose/regulator specified by manufacturer.
• Do not mistake brown or black accumulation of grease and
smoke for paint. Interiors of gas grills are not painted at the
factory . Apply a strong solution
of detergent and water or use a grill cleaner with scrub brush
on insides of grill lid and bottom. Rinse and allow to completely
air dry.
• Wash with warm soapy water and wipe dry.
Do not use citrisol, abrasive cleaners, degreasers or a
concentrated grill cleaner on plastic parts. Damage to and
failure of parts can result.
Because of glass-like composition, most
residue can be wiped away with baking soda/water solution or
specially formulated cleaner. Use nonabrasive scouring powder
for stubborn stains.
Wash with mild detergent or nonabrasive
cleaner and warm soapy water. Wipe dry with a soft
nonabrasive cloth.
• Turn gas off at LP tank.
• Important: Make sure gas is off at LP tank before checking
valves
Low
•
(and should never be painted)
Do not apply a caustic grill/oven cleaner to painted
surfaces.
Plastic parts:
• Porcelain surfaces:
• Painted surfaces:
"Troubleshooting"
s
OFF
OFF
OFF
Match-Lighting
s Do not lean over grill while lighting.
1. Open lid.
2.
3.
4.
Turn on gas at LP tank.
Place lit match into match lighting hole beneath grill bottom as
shown below.
Push in and turn RIGHT knob to (Ignite). Be sure burner
lights and stays lit.
Light left burner by turning LEFT knob to (Ignite).
Before Your First Cookout
• Light burners, check to make sure they are lit, then close the lid
and warm up grill on (High) for 15 minutes. Curing of paint
and parts will produce an odor only on first lighting. Do not
warm up grill with knobs on (Ignite). Knobs and handle may
become uncomfortably hot if knobs are left on (Ignite).
8 • 461644604
Ignitor Lighting The Sideburner
Match Lighting
s Do not lean over grill while lighting.
1.
2.
3.
.
1.
2.
3.
Turn gas on at LP tank..
Push in and turn sideburner knob to High.
or use match.
Place lit match near burner.
Push ignitor button rapidly (up to 5 times) to light. Be sure
burner lights and stays lit.
If burner does not light, turn knob to OFF, wait 5 minutes, then
try again
Push in and turn sideburner knob to High. Be sure burner
lights and stays lit.
4
Turn on gas at LP tank.