Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
CAUTION
FACT: Sometimes spiders and other small insects climb into
the burner tubes attached to the burners. The spiders spin
webs, build nests and lay eggs. The webs or nests
can be very small, but they are very strong
and can block the flow of gas. Clean
burners prior to use after storing, at the
beginning of grilling season or after a period
of one month not being used.
NATURAL HAZARD • SPIDERS
Spider guards are on the air intakes in an effort to reduce this
problem, but it will not eliminate it! An obstruction can result
in a "flashback" (a fire in the burner tubes). The grill may still
light, but the obstruction does not allow full gas flow to the
burners.
Smell gas.
Burner(s) will not light.
A small yellow flame from burner (should be blue).
Fire coming from around or behind control knob.
Follow the “ ” instructions.
Clean burners often. Use a 12” pipe cleaner to clean out the
burner tubes. You may also force a stream of water from a
hose nozzle through burner tubes to clean them.
IF YOU EXPERIENCE THE FOLLOWING:
1.
2.
3.
4.
STOP!
Immediately turn off gas at LP tank!
SOLUTION:
Wait for grill to cool.
Cleaning The Burner Assembly
Storing Your Grill
• Clean cooking grates.
• Store in dry location.
• When LP tank is connected to grill, store outdoors in a well-
ventilated space and out of reach of children.
• Cover grill if stored outdoors. Choose from a variety of grill
covers offered by manufacturer.
• Store grill indoors ONLY if LP tank is turned off and
disconnected, removed from grill and stored outdoors.
• When removing grill from storage, follow “
” instructions before starting grill.
Cleaning the Burner
Assembly
Cleaning The Burner Assembly
Follow these instructions to clean and/or replace parts of burner
assembly or if you have trouble igniting grill.
1.
2. Remove cooking grate, VapoRISER Bar, and grease cup.
3. Disconnect ignitor wire from burner electrode and remove
the two burner screws from beneath grill bottom.
4. Carefully lift burner assembly up and away from valves.
5. Clean ceramic portion of electrode with rubbing alcohol and
a swab.
6. Clean outside of burner with soap and water. Lay burner
upside down on a flat surface, insert garden hose to force
water through tubes. Make sure water comes out of all
burner holes. Open clogged holes with a thin wire. Shake
out excess water and examine holes. Due to normal wear
and corrosion, some holes may become enlarged. If any
large cracks or holes are found, replace burner.
7. If grill is to be stored, coat burner lightly with cooking oil.
Wrap in protective cover to keep insects out.
8. If not storing grill after cleaning, replace burner into grill
bottom.
9. Attach burner to grill bottom with screws and attach ignitor
wire to burner electrode
10. Reposition VapoRISER Bar and cooking grate. Attach clean
grease cup beneath grill bottom.
11. Before cooking again on grill, perform a “Leak Test” and
“Burner Flame Check”.
Turn gas off at control knobs and LP tank.
VERY IMPORTANT: Burner tubes must reengage valve
openings. See illustrations below.
Do not use ceramic briquets or charcoal in your gas
grill.
s
Valve
Burner Tube
461644304 • 9