T-Fal Use Grill & Panini Maker Gas Grill User Manual


 
7
Fully unroll the power cord.
Make sure that the electric power supply is compatible with the power rating
and voltage indicated on the bottom of the appliance.
Always plug the appliance into an earthed socket.
If an extension cord is used:
- it must have an grounded lead;
- take all necessary precautions so no-one trips on it.
If the power supply cord is damaged, it must be replaced by the manufacturer's
after sales service center or a similarly qualified person in order to avoid a
hazard.
Plug the cord into a main socket: the indicator light (10) comes on and the appliance
starts to heat up.
Never leave the appliance plugged in when not in use.
Never run the appliance empty.
The appliance might make a slight sound when started.
Set the thermostat to the position indicated in the cooking table.
The position of the thermostat during pre-heating is the same as that used for cooking.
Pre-heat the appliance for about 5 minutes.
Pre-heating is over when the indicator light switches off.
To preserve the non-stick properties of the coating, avoid excessive pre-heating with
the appliance empty.
On first use, there may be a slight odor and a little smoke during the first few minutes.
Never leave the appliance unattended when in use.
CONNECTION AND PRE-HEATING