Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
4) SECURING THE BARBECUE
To secure the barbecue to the worktop the
fastening clamps accompanying this booklet
must be assembled. The following procedures
must be carried out to do this:
remove all movable parts from the barbecue;
turn the appliance over taking care to place it
on a soft surface to avoid damaging the external
surfaces;
remove the clamps "G" from the package and
install them according to the diagram in fig. 4.
After these steps have been carried out, the
special gasket that prevents liquids from leaking
can be installed. To fit this gasket correctly,
please strictly follow the directions below:
- detach the gasket strips from their support taking
care that the transparent protection remains
attached to the gasket;
- put the gasket "E" (fig. 4) in the correct position
under the edge of the table top, so that the outer
side of the gasket fits perfectly with the external
perimeter of the worktop. The ends of the strips
must fit without overlapping;
- make sure the gasket adheres to the countertop
evenly all around, press it down with your
fingers, then remove the protective strip of the
gasket and position the barbecue in the opening
made in the worktop;
- secure the appliance by tightening the clamp
screws "F" (see fig. 5).
- In order to prevent any accidental contact with
the surface of the heated barbecue during use, a
separation in wood must be inserted and
fastened with screws at a minimum distance of
60 mm from the top (fig. 6).
WARNING: Note that the adhesive which joins the
plastic laminate to the worktop must be resistant
to temperatures of no less than 150°C to prevent
the covering from detaching.
The installer is advised that the rear wall,
adjoining and surrounding surfaces of the
barbecue must be resistant to a temperature of
75K.
FIG. 4 FIG. 5 FIG. 6
INSTALLATION
ABCDE
BARBECUE 285 485 60 60 150 min.
19
USEFUL MEASUREMENTS
(mm)