Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
13
To replace batteries:
• Slide belt clip to the left to remove.
• Press tab down on battery cover and pull out.
• Install 2 “AAA” Alkaline batteries. Check positive (+) and negative (-) symbols, on the case and
battery, to insure proper installation.
• Replace the battery cover.
• Remove batteries before storing remote control.
To test frequency range:
• Turn unit on.
• Use remote to turn light on and off as you move away from unit.
• Remote control is out of frequency range when light will no longer turn on and off.
IMPORTANT
• Do not leave remote control exposed to sunlight for prolonged periods of time.
• Remote control has frequency range of up to 100ft (30m).
• Test frequency range before and during use.
TROUBLESHOOTING
If the remote is not working properly or not interfacing correctly with the controller, it may be due to
weak batteries, batteries being incorrectly installed or the remote is not correctly linked to controller.
Possible solutions
• Replace batteries and install according to image in battery housing
• Link remote and controller by:
a. Turn Controller & Remote “ON”,
b. Press and HOLD “SET TEMP” on controller for 3 seconds.
c. On the Remote press “MEAT PROBE”, “LIGHT”, “MEATPROBE”, “LIGHT” (all buttons must be
pressed within 5 seconds of each other) A short beep will occur after each button press.
HOW TO USE CONTROL PANEL & REMOTE CONTROL
CAUTION
• Keep batteries away from small children. If battery is swallowed consult a physician immediately.
• Be sure to insert batteries correctly. Improper installation may result in leaks and/or possible explosion.
• Do not dispose of batteries in fi re.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh,etc) batteries.
*Batteries not
included
6
ARMADO
• ANTES DE ARMARLA, LEA DETENIDAMENTE TODAS LAS INSTRUCCIONES.
• ARME LA UNIDAD EN UNA SUPERFICIE LIMPIA Y PLANA.
• HERRAMIENTAS NECESARIAS: DESTORNILLADOR PHILLIPS
PASO 1
Ubique la rueda (5) en la parte
inferior del ahumador (1), como
muestra la ilustración.
Inserte el pata roscada ajustable (4)
en la parte inferior de la rueda (5)
Fije la rueda (5) a la parte inferior
del ahumador (1), utilizando tornillos
Phillips (A).
Repita el mismo paso en el lado
opuesto.
Nota: Ajuste la altura del pata
roscada ajustable, girándolo hacia la
derecha o izquierda, de modo que el
ahumador quede nivelado. Una vez
que esté nivelado, fi je la posición de
las patas traseras con las tuercas de
tensión.
PASO 2a
Coloque el panel de control (6) en-
cima del cuerpo del ahumador (1),
como se ilustra.
Alinee las ranuras del conector del
panel de control con las pestañas
del conector del ahumador, y realice
la conexión entre ellos, como se
ilustra.
PASO 2b
Monte el panel de control al insertar
la cabeza del tornillo estabilizador
en la ranura.
Nota: Es probable que el tornillo
estabilizador necesite ajustarse
ligeramente para que quede a la
perfección.
A
5
A
1
4
Tuercas
de tensión
1
6
Tornillo
Estabilizador
Ranura