Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
14
Regency IG34 Gas Inbuilt Fireplace
INSTALLATION
OPTIONAL STAINLESS STEEL INNER PANEL INSTALL
Before you start:
Stainless panels must be inspected for scratches and dimples prior to installation. All claims to be recorded at this time. Claims for
damage after installation will not receive consideration.
To protect the fi nish during installation and handling - cotton gloves MUST be worn at all times while handling the panels (even
when removing protective coating).
Stainless panels will discolor a little during normal operation. This is normal and should not be considered a defect.
All hand and fi nger marks MUST be cleaned off with a soft cloth and a stainless steel cleaner. Most stainless steel cleaners leave a
fi lm/residue on the surface of the panels. Use an ammonia based cleaner (ie. glass cleaner) to remove this fi lm before applying heat to
the unit. Failure to do this will result in burn stains on panels which you will be unable to remove. This is not a warranty item.
1) Remove faceplate, inner door frame and screen if
already installed. Refer to page 18 in the instruction manual.
2) Remove the glass door by undoing 2 latches - lift up and out.
Refer to page 17 in the manual for detailed instructions.
3) Remove all the logs if installed and set aside carefully.
4) Loosen the 4 screws securing the brackets that hold the existing
back and side panels in place.
5) Remove the two back brackets and screws (set aside) fi rst, then
remove the back panel by lifting it up slightly, tilt it forward,
then lift it out.
6) Remove the two side brackets and screws (set aside) - then
remove the side panels by tilting the top in and lifting them out.
7) Orient the stainless side panels with the larger fold in the
panel facing in towards the burner and facing the back of the
fi rebox.
8) Secure the stainless panel with original bracket and screw - repeat
procedure on the opposite side.
9) Reinstall the (original black) back panel - secure with 2 brackets
and 2 screws (ones that were removed initially).
10) Reinstall the logs, glass door, inner door frame with screen
and fi nally the faceplate. See manual for detailed instructions.
Final installation of optional stainless panels.
Larger fold in the
metal.