Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
15
Normalisation N
Pressing the Normal ( ) Button on the remote control, will return all picture settings to the factory preset
levels. This is called “Normalisation”.
Normalisation will only occur if the Picture Menu is not displayed when the Normal ( ) Button is pressed.
Picture Menu
Push the PICTURE button.
Select the option.
Adjust the chosen option.
Push the TV/AV at any time to return
to watching TV.
MENU
Contrast
Brightness
Colour
Sharpness
Tint (AV only)
Colour temperature
P-NR
Scan mode
The Viewing mode control allows you to change the Picture setting between Dy-
namic, Normal and Cinema.
Dynamic For viewing in brightly lit rooms. This menu selects higher than normal
levels of Brightness and Contrast.
Normal For viewing in normal (evening lighting) environments. This menu
selects the normal levels of Brightness and Contrast.
Cinema For viewing in a dark room. This menu selects reduced levels of
Brightness and Contrast.
Increase or decrease the level of these options to suit your personal preference.
The Colour temperature control allows you to change the White balance setting
between Standard, Warm and Cool. .
The P-NR (Picture Noise Reduction) system is designed to reduce picture noise
during poor quality reception conditions. Pushing the left or right buttons will change
the setting between Off, Strong, Weak and Auto.
The Scan mode control allows you to change the Picture refresh setting between
75/883i, 100Hz and Progressive.
The 75/883i mode gives a faster refresh rate and more lines than a standard
television. 100Hz will give a steady picture for most signals. Progressive is
recommended when receiving NTSC signals.
NOTE: The scan mode function is not available when Picture in Picture is being
used.
Menu
Colour Temperature Standard
P-NR Auto
Contrast
Brightness
Co lour
Sharpness
Scan mode 75 / 833i
NTSC-Tint
Picture menu
RF Mode
Me nu
Colour Temperature Standard
P-NR Auto
Co ntrast
Brightness
Co lour
Sharpness
Picture menu
Scan mode 75 / 833i
AV Mode
Contrast
Notes:
1. You can change the level for each function (Contrast, Brightness, Colour, Sharpness and NTSC-Tint) for
each picture menu option.
2. Picture menu levels can be set for TV, AV1, AV2, AV3, AV4 and AV5 modes.
3. NTSC-TINT only appears when the TV is receiving NTSC signals and the television is in the AV mode.
4. Only CONTRAST will be displayed in TELETEXT mode.
5. We recommend that you set the Scan mode to Progressive when viewing a PAL 60 or NTSC
transmission. When viewing a PAL transmission (other than PAL 60) with the Scan mode set to
Progressive, the screen will flicker. This is not a fault.
6. The Multipip function will not operate when a Progressive signal is used.