Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
W415-0372 / 02.12.03
8
• Do not try to light any appliance.
• Do not touch any electric switch; do
not use any phone in your building.
• Immediately call your gas supplier from a neighbour's
phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire de-
partment.
Upon completing the gas line connection, a small amount
of air will be in the lines. When first lighting the burner, it will
take a few seconds for the lines to purge themselves of
this air.
WARNING: Read and follow the safety and lighting instructions page in this manual and on labels on the appliance. IF
YOU DO NOT FOLLOW THESE INSTRUCTIONS PRECISELY, A FIRE OR EXPLOSION MAY RESULT AND YOU MAY BE
SERIOUSLY INJURED.
A. This appliance must be lit by hand while following
these instructions exactly.
B. Before operating smell all around the appliance area
for gas and next to the floor because some gas is
heavier than air and will settle on the floor
C. Use only your hand to turn the manual gas control
valve. Never use tools. If the valve will not turn by hand,
do not try to repair it. Call a qualified service technician.
Force or attempted repair may result in a fire or explo-
sion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician to
inspect the appliance and replace any part of the control
system and any gas control which has been under water.
1. Locate the manual gas control valve.
2. Place the firestarter near the burner ports on top of
the burner. Light the firestarter. For a Natural Gas
unit, turn on the ON/OFF valve slowly at the unit. For
a LP unit, turn the valve in the LP tank counter clock-
wise all the way and then turn on the ON/OFF valve
slowly at the unit.
3. If the burner does not light before the match goes out,
immediately turn the gas off.
4. Wait at least five (5) minutes to clear out any gas.
Then smell for gas including near the base of the
unit. If you smell gas, STOP! Refer to the safety infor-
mation in the owner's manual. If you don't smell gas,
repeat step 2.
Turn the ON/OFF valve to the off position at the unit for
Natural Gas unit.
For LP unit, turn the ON/OFF valve to the off position at the
unit and then turn the valve on the LP tank to the OFF
position clockwise.
OPERATION
FOR YOUR SAFETY READ BEFORE LIGHTING:
WHAT TO DO IF YOU SMELL GAS
LIGHTING INSTRUCTIONS
TO TURN OFF GAS
Once the purging is complete, the burner will light and
operate as indicated in the instruction manual. Subsequent
lighting of the appliance will not require such purging un-
less the gas supply has been disconnected.
The propane regulator in this appliance is equipped
with a low flow protection device. Unless the propane
cylinder valve is opened before the patioflame valve,
the gas flow will be reduced resulting in a very small
flame.
To reset this device, shut off the patioflame valve, then
the propane cylinder valve.
Next, disconnect the regulator adaptor from the tank
and then reconnect. Follow the lighting procedure en-
suring the propane cylinder valve is opened before the
unit is.
NOTE