Napoleon Fireplaces GLVF30P Fire Pit User Manual


 
W415-0530 / 12.14.05
2
TABLE OF CONTENTS
Due to high temperatures, the appliance should be
located out of traffic and away from furniture and
draperies.
Children and adults should be alerted to the
hazard of high surface temperatures and should
stay away to avoid burns or clothing ignition.
Young children should be carefully supervised when
they are in the same room with the appliance.
Do not place clothing or other flammable material
on or near the appliance.
Any safety screen or guard removed for servicing
an appliance must be replaced prior to operating
the heater.
Installation and repair should be done by a quali-
fied service person. The appliance should be in-
spected before use and at least annually by a pro-
fessional service person. More frequent cleaning
may be required due to excessive lint from carpet-
ing, bedding material, etc. It is imperative that con-
trol compartments, burners and circulating air pas-
sageways of the appliance be kept clean.
Any change to this heater or it’s controls can be
dangerous.
The fireplace and gas logs function as a system. If
the fireplace is not drafting properly and spilling into
the room (check with a match or a smoke stick),
reposition the damper clamp until a positive draft
is obtained by opening the damper. If negative
pressure in home prevents having a positive draft,
consult an air quality specialist.
The gas log heater must be secured to the
fireplace floor to ensure that the position is
not changed while adjusting the controls.
Sooting and an improper burn may result
from shifting of the gas logs by moving the
unit. A gas leak could be caused by moving
the grate.
If you are installing the unit into a sunken
fireplace, you must raise the fireplace floor
to allow access to the gas log controls.
Raising the floor ensures adequate air flow
and guards against sooting. The fireplace
floor must be raised using noncombustible
materials.
This appliance is for installation only in a
solid-fuel burning masonary or UL 127
factory-built fireplace or in a listed ventless
firebox enclosure. It has been design
certified for these installations. Exception:
DO NOT install this appliance in a factory-
built fireplace that includes instructions
stating it has not been tested or should not
be used with unvented gas logs.
This appliance is only for use with the type
of gas indicated on the rating plate. This
appliance is not convertible for use with
other gases.
A fireplace screen must be in place when
the appliance is operating and, unless other
provisions for combustion air are provided,
the screen shall have an opening for
introduction of combustion air.
Any glass doors shall be completely opened
when the appliance is in operation.
State or local codes may only allow operation
of this appliance in a vented configuration.
Check your state or local codes.
Do not use a blower insert, heat exchanger
insert or any other accessory not approved
for use with this appliance.
2 Warnings
3 Warranty
4-5 General Instructions
General Information
Maintenance and Cleaning
Air Shutter
Minimum Fireplace Size
Andiron and Grate Assembly
Gas Piping
6-7 Installing In An Unvented Application
Combustion and Ventilation
Determining Confined or Unconfined
Space
7 Installing In A Vented Application
Damper Stop Installation
8-9 Operating / Maintenance
Operating Instructions
Lighting Instructions
ODS Pilot Cleaning
Match Lighting Instructions
10 Log Placement
Logo Placement
11 Finishing
Rating Plate
12 Replacement Parts
Accessories
WARNINGS
PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE