Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
4
TOOLS REQUIRED
Check for missing or damaged parts before you begin and consult your local retailer if neccessary.
3/8
3/8 WRENCH
OR NUTDRIVER
ADJUSTABLE
WRENCH
PHILIPS
SCREWDRIVER
HAMMER
GAS AND ELECTRICAL PIPING
The piping up to the gas grill is the responsibility of the installer and piping should be located as shown in the
built-in instructions. Do not use hose to connect the unit. It must be connected with either rigid pipe, copper tube or an
approved flexible metal connector. The installation must comply with CAN B149.1 Natural Gas and Propane installa-
tion code in Canada, or to the National Fuel Gas code, ANSI Z223.1 in the United States. The minimum recommended
piping size is NPS 1/2" for rigid pipe, and 1/2" OD for copper tubing (based on a 20 ft run). Longer runs may require
larger sizes to conform with CAN B149.1. Propane Gas Installation Code in Canada or to the National Fuel Gas Code,
ANSI Z223.1 in the United States. Look to the manual that came with the gas
grill for further instructions.
To ease installation and piping, removable knockouts have
been provided in the side panels and in the center of each
backpanel. The knockouts in the side panels should be removed
before the cabinets are bolted in a row. Only remove the knock-
outs that are required for the piping of any gas, plumbing or
electrical lines.
KNOCKOUTS