Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
• USE OUTDOORS ONLY.
• DO NOT USE THIS APPLIANCE INSIDE THE BOAT OR ANY ENCLOSED SPACE.
• GRILLS RADIATE HEAT. CLEARANCE FROM COMBUSTIBLES, 24” SIDES AND BACK. NEVER USE UNDER
AWNINGS, PATIO COVERS, ETC.
• USE PROPANE GAS ONLY. FUEL STORAGE SHOULD BE IN COMPLIANCE WITH THE AMERICAN BOAT AND
YACHT COUNCIL (ABYC) STANDARDS A-1 (9), MARINE LIQUIFIED PETROLEUM GAS (LPG) SYSTEMS.
• FOR NATURAL GAS APPLICATION CONTACT MAGMA.
• ALWAYS LIGHT GRILL WITH LID OPEN.
• NEVER LEAVE HOT GRILL UNATTENDED.
• USE HOT PAD WHEN HANDLING.
• ALWAYS TURN GRILL OFF AFTER USE.
• NEVER LEAVE GAS CYLINDERS AND REGULATOR CONNECTED WHEN STOWED.
• STORE GAS CYLINDERS IN WELL VENTILATED AREA.
• DO NOT STORE GAS CYLINDERS INDOORS, IN DIRECT SUNLIGHT, BELOW DECKS ON BOATS, OR IN LOCKERS
NOT APPROVED FOR BUTANE OR PROPANE STORAGE.
• CAUTION: CHECK FOR GAS LEAKS EACH TIME CYLINDER IS CHANGED.
• NEVER CHECK FOR GAS LEAKS WITH A FLAME!
• DO NOT BLOCK, RESTRICT, OR OTHERWISE OBSTRUCT COMBUSTION OR VENTILATION
AIR OPENINGS.
• DO NOT MODIFY THIS APPLIANCE.
• CHECK THAT VALVE SEALING WASHER (A) IS IN PLACE AND IN GOOD CONDITION
BEFORE CONNECTING THE GAS CONTAINER.
• INSTALL CANISTERS IN WELL VENTILLATED AREA AND AWAY FROM OPEN FLAME, HEAT
SOURCE OR SPARKS. KEEP AWAY FROM OTHER PEOPLE OR FLAMMABLE MATERIALS.
IMPORTANT SAFETY WARNINGS
INSTALLATION INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE OPERATING.
2
Each Magma
®
Gas Grill is individually fire tested before it leaves the factory.
For this reason, the burner on your grill may be slightly discolored.
CONTROL VALVE REGULATOR
•Uses standard 1-lb. disposable propane canisters (DOT-39 NRC 228/286).
•Prior to installing valve, become familiar with the valve function and graphics
on valve knob. Never force the knob. Always turn or push gently.
•Turn control valve to “lock” and install gas canister being careful not to
cross the threads. Check for leaks prior to use, by brushing soapy water
solution around threads and orifice hole checking for bubbles.
•Position valve with gas bottle as shown (A). Gently insert valve stem into
valve chamber. Rotate until valve stem key aligns with lock detent allowing
valve to fully insert. Rotate gas canister down, so knob faces you (B) or
straight up (C) depending on application.
(A)
(B)
(C)
A
Valve will feel loose and will rotate easily. Even though the valve feels loose, it will not
leak. The valve was designed to be loose fitting in order to allow safe, easy installation
and removal of the propane canister and so it easily swings without resistance to fit all
applications.