Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
MAINTENANCE
6
ABOUT STAINLESS STEEL
Stainless steel exposed to prolonged periods of high heat will change color and texture.
Magma grills require no preheating. Not preheating will keep your grill cooler and
greatly extend the life and beauty of your grill. Texture and color change is normal on
interior components and will not affect the products operation or performance.
Exterior Stainless Steel Components
Cleaning the exterior surface after every use will help prevent discoloration. Use soapy
water with a soft cloth or sponge. Rinse thoroughly with fresh water and dry. We
recommend covering the grill between uses. Optional covers are available from Magma
retailers or direct from Magma. CAUTION: ABRASIVE PADS OR CLEANERS WILL DAMAGE
THE FINISH.
Interior Components
Remove heavy residue from barbeque and empty grease tray between each use. We
recommend complete disassembly and cleaning at least once a year depending on
amount of use (see page 5) and always prior to long term storage. For burnt-on residue
we recommend Easy-Off brand Oven & Grill Cleaner. If cleaner is used on liner or lid,
complete disassembly is recommended to remove any cleaner residue left between
components. Wash all components with soapy water after using cleaner. CAUTION:
AVOID CONTACT OF IGNITER AND ELECTRODE WIRE AND WIRE CONNECTORS WITH
OVEN CLEANER.
Grill Grates
Clean with brass wire brush while grill is warm. Use Oven & Grill cleaner for burnt-on
residue. Wash with soapy water and dry prior to storage.
Ceramic Electrode
Located just beside the burner, it should be kept clean of grease and debris. Be careful
not to damage the ceramic insulation or bend the wire. See page 5 for electrode spark
adjustment.
Control Valve
All valves are set and tested at our factory. Do not attempt to adjust or disassemble the
valve in any way. Call Magma if you suspect it is not adjusted properly. Clean valve with
a cloth and remove any debris obstructing the gas outlet orifice using a pin or needle.