Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
MAINTENANCE
About Stainless Steel - Stainless steel exposed to prolonged periods of high heat will change
color and texture. Magma grills require no preheating. Not preheating will keep your grill cooler
and greatly extend the life and beauty of your grill. Texture and color change is normal on
interior components and will not affect the product’s operation or performance.
Exterior Stainless Steel Components - Cleaning the exterior surface after every use will help
prevent discoloration. Use soapy water with a soft cloth or sponge. Rinse thoroughly with fresh
water and dry. We recommend covering the grill between uses. Optional covers are available
from Magma retailers or direct from Magma. CAUTION: ABRASIVE PADS OR CLEANERS WILL
DAMAGE THE FINISH.
Interior Components - Remove heavy residue from grill and empty grease tray between
each use. We recommend complete disassembly and cleaning at least once a year depending
on amount of use (see page 5) and always prior to long term storage. For burnt-on residue we
recommend Easy-Off brand Oven & Grill Cleaner. If cleaner is used on liner or lid, complete
disassembly is recommended to remove any cleaner residue left between components. Wash
all components with soapy water after using cleaner. CAUTION: AVOID CONTACT OF IGNITER
AND ELECTRODE WIRE AND WIRE CONNECTORS WITH OVEN CLEANER.
Grill Grates - Clean with brass wire brush while grill is warm. Use Oven & Grill cleaner for
burnt-on residue. Wash with soapy water and dry prior to storage.
Ceramic Electrode - Located just beside the burner, it should be kept clean of grease and
debris. Be careful not to damage the ceramic insulation or bend the wire. See page 5 for
electrode spark adjustment.
Control Valve - All valves are set and tested at our factory. Do not attempt to adjust or
disassemble the valve in any way. Call Magma if you suspect it is not adjusted properly. Clean
valve with a cloth and remove any debris obstructing the gas outlet orifice using a pin or needle.
Repair/Replacement Parts - See Magma’s Website for a complete list of Repair or
Replacement Parts. www.MagmaProducts.com
6
USING GRILL WITH ON-BOARD LPG (PROPANE) SYSTEMS
Propane (LPG)
Gas Regulator
A10-225
Hose Kit
To other LPG
appliance
or use cap
Shut off
valve
Cylinder Valve
Gauge
Type 3
Valve
Solenoid
Gourmet
Gas Grill
Typical Marine &
R.V. Application
Align valve stem key
to valve chamber
lock detent and rotate
Gourmet
Gas Grill
Gourmet
Gas Grill
Type 3
Valve
• Magma On-Board LPG (Propane) Valves
and Hose Kits allow Magma Grills to be
installed within a boats existing on-board,
pre-regulated low pressure LPG (Propane)
system.
• Use only Magma Type 3 Low
Pressure LPG (Propane) Valves. See
our Valve Application Guide at www.
MagmaProducts.com for correct valve.
• In North America use Magma A10-225
LPG 10' Hose Kit in conjunction with
Type 3 Valve. Outside North America check
your local dealer for proper hose and fittings.
• A primary shutoff valve (supplied with
A10-225 hose kit) must be used with this
control valve at point of connection into
your system. This allows shut off of gas
supply to hose leading to grill.