KitchenAid KFBP102LSS Outdoor Cart User Manual


 
5
plastic
hose
inlet
connector
filter
8.Connect the plastic line from the
water filter to the faucet connection and
tighten securely.
plastic
line
filter
Taking care of your
Bar Cart
Wipe up any water spills on the exterior.
Water can cause spots.
Stainless steel surfaces: Use any cleaner
acceptable for use on stainless steel.
Always rub in the direction of the
manufacturer's polishing marks.
Other surfaces: Clean with warm
dishwashing soap and water.
Cleaning
General Tips
IMPORTANT:
Always follow label
instructions on cleaning products.
For routine cleaning, wash with soap and
water using a soft cloth or sponge. Rinse
with clean water and dry at once with a
soft, lint-free cloth to avoid spots and
streaks.
Never use steel wool, as it will scratch the
surface.
Use of the accessory cover designed for
Outdoor Bar Cart will protect finish from
weather.
Stainless Steel
IMPORTANT:
Do not use soap-filled
scouring pads, abrasive cleaners,
Cooktop Polishing Creme, steel wool,
gritty wash cloths or paper towels.
Cleaners should not contain chlorine.
Damage may occur.
Rub in direction of grain to avoid
scratching or damaging the surface.
Food spills should be cleaned as soon as
possible. Spills may cause permanent
discoloration.
• Use Stainless Steel Cleaner & Polish
(Part #4396095). See “Requesting
9.Install water inlet connection
through hole provided in cabinet rear
panel.
plastic hose
connector
inlet
connector
nut
cabinet
panel
10.Attach the plastic cold water
hose from the water inlet connection to
the inlet side of the filter. Use N.S.F.
U.P. C .-listed water connection line for
water supply to inlet connector. Potable
water supply system to be connected to
inlet connector per local code
requirements.
11.Unwrap the bottle rail and
bottle cap catch pan. Position them over
the key-lock studs and slide down to lock
in place.
12.Unwrap the sliding cover and
place into frame on top of the ice bin.
13.Rotate the side shelves up into
their locked position or leave down as
needed.
14.Lock the front locking caster
wheels when in use.
Assistance or Service” on Page 7 to
order.
• Use a mild liquid detergent or all-
purpose cleaner according to label
instructions.
• Rinse with clean water and dry at once
with soft, lint-free cloth to avoid spots
and streaks.
• Use vinegar to remove hard water
spots. Rinse with water and dry
thoroughly.
• Use a glass cleaner to remove
fingerprints.
Exterior
The quality of this material resists most
stains and pitting, providing that the
surface is kept clean and protected.
• Apply stainless steel polish to all areas
before first use. Re-apply after each
cleaning to prevent permanent damage
to surface.
• Cleaning should always be followed by
rinsing with clean warm water.
• Use a metal polish or stainless steel
brightener to remove fingerprints, water
spots, oxidation and food stains. Always
follow the manufacturer’s directions.
• Wipe the surface completely dry with a
soft cloth.
Winterization of faucet and
drain system
When temperatures are below 35° F for
an extended period of time:
1. Tu rn off water source to sink.
2.Remove potable water supply
system from connection and
store appropriately.
3.Remove filter
from its connection and
store inside in a warm
dry area.
4.Disconnect drain
traps and 1/4" tubing
from the filter connector
and allow to drain.
5.Cover bar cart with accessory
cover or tarp.
plastic
hose