Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
36
CONTROL PANEL GRAPHICS
IMPORTANT: To avoid damage to control panel graphics, do not
use steel wool, abrasive cleaners or oven cleaner.
Do not spray cleaner directly onto panel.
Cleaning Method:
■ Clean around the burner labels gently; scrubbing may remove
printing.
■ Mild detergent, soft cloth and warm water.
■ Rinse and dry.
ROTISSERIE SPIT ROD AND FORKS
Cleaning Method:
■ Wash with mild detergent, using a soft cloth and warm water.
■ Rinse and dry.
■ For stubborn areas, use a multipurpose cleaner, a heavy-duty
scrub sponge or mild abrasive cleaner.
DRAWERS
Cleaning Method:
Routine cleaning
■ Paper towel and spray glass cleaner:
Make sure drawer is cool. Follow manufacturer’s instructions.
■ Warm, soapy water or all-purpose cleaner and a nonabrasive,
plastic scrubbing pad:
Wash, wipe with clean water and dry thoroughly.
Stubborn stains and baked-on residue
Rub in direction of grain to avoid damaging.
■ Mildly abrasive cleanser or stainless-steel cleaners and a
damp cloth or sponge.
Wash, wipe with clean water and dry thoroughly. Repeat if
necessary.
RACKS
Cleaning Method:
■ Steel-wool pad and warm, soapy water:
Wash, rinse and dry thoroughly.
Drawer Slides
The drawer slides allow you to fully extend the drawer for easier
cleaning. If necessary, the drawer can be removed.
NOTE: Load capacity for the drawer and slides is 100 lbs (45 kg).
Drawer Removal
Remove all items from inside the warming drawer, and allow the
warming drawer to cool completely before attempting to remove
the drawer.
To Remove:
1. Open drawer to its full open position.
2. Locate the black tabs on both sides of the drawer.
3. Press the tab down on the right side and lift tab up on the left
side at the same time, then pull drawer out another inch to
disengage latch.
4. Hold the drawer by its sides (not by its front). Pull it slowly all
the way out.
To Replace:
1. Align the drawer glides with the receiving guides.
2. Push drawer in all the way.
3. Gently open and close the drawer to ensure it is seated
properly on the guides.
Cabinet Door Alignment - Style 2
(internal hinge) Only
Your cabinet doors can be realigned if necessary.
1. Check door to determine alignment requirements.
2. Open the cabinet door.
3. Locate and loosen the 4 door hinge mounting screws ½ turn.
4. Adjust the top or bottom of the door in the direction
necessary to align the door.
5. Tighten the 4 door hinge mounting screws.
6. Close the door and check alignment.
7. Readjust the door using steps 2 through 6 if necessary.
8. Repeat steps 1 through 7 on the other door if necessary.
A. Tab
A
A.Drawer glides
B. Receiving guides
A. Top screws (2 - underside of frame)
B. Bottom screws (2)
A
B
A
B