KitchenAid KFRU368T Gas Grill User Manual


 
6
INSTALLATION REQUIREMENTS
Tools and Parts
Style 1 - Freestanding Outdoor Grills
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools Needed
Parts Supplied
Gas pressure regulator/hose assembly set for 11" WCP LP
gas (attached to manifold).
Rotisserie motor mounting bracket
Rotisserie motor
Rotisserie forks
Rotisserie spit
Smoker box
2 warming drawer pans
1 single-prong plug/transformer assembly
Parts Needed
20 lb LP gas fuel tank
Tools and Parts
Style 2 - Built-In Outdoor Grills
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools Needed
Parts Needed
Gas line shutoff valve
½" male pipe thread nipple for connection to pressure
regulator
LP gas-resistant pipe-joint compound
CSA design-certified outdoor flexible stainless steel
appliance connector [4-5 ft (1.2-1.5 m)] or rigid gas supply
line as needed.
Parts Supplied
Convertible regulator set for 4" WCP Natural gas.
2 single-prong plug/transformer assemblies.
Rotisserie motor mounting bracket
Rotisserie motor
Rotisserie forks
Rotisserie spit
Smoker box
Location Requirements
Select a location that provides minimum exposure to wind and
traffic paths. The location should be away from strong draft
areas.
Do not obstruct flow of combustion and ventilation air.
Clearance to combustible construction for built-in and
freestanding outdoor grills:
A minimum of 24" (58 cm) must be maintained between the
grill hood, sides and back and any combustible construction.
A 24" (58 cm) minimum clearance must also be maintained
below the cooking surface and any combustible construction.
Rotisserie
A 6" (15.2 cm) minimum clearance is needed for the rotisserie
motor.
A grounded, 3-prong outlet located to the left of the grill is
required. See “Electrical Requirements” section.
Tape measure
Small, flat-blade screwdriver
Flat-blade screwdriver
#2 and #3 Phillips screwdriver
Level
Wrench or pliers
Pipe wrench
Scissors or cutting pliers
(to remove tiedowns)
Noncorrosive leak-
detection solution
Tape measure
Small, flat-blade screwdriver
Flat-blade screwdriver
#2 and #3 Phillips screwdriver
Level
Wrench or pliers
Pipe wrench
Scissors or cutting pliers
(to remove tiedowns)
Noncorrosive leak-
detection solution
WARNING
Explosion Hazard
Do not store fuel tank in a garage or indoors.
Do not store grill with fuel tank in a garage or indoors.
Failure to follow these instructions can result in death,
explosion, or fire.
WARNING
Fire Hazard
Do not use grill near combustible materials.
Do not store combustible materials near grill.
Doing so can result in death or fire.