KitchenAid KFRS361T Gas Grill User Manual


 
15
1. Place grill into outdoor enclosure, but leave enough room in
back to connect to gas supply and electrical plug-in.
2. Make gas connections.
A combination of pipe fittings must be used to connect the
grill to the existing gas line.
If local codes permit, use an outdoor flexible stainless
steel tubing gas connector, design-certified by CSA
International, to connect the grill to the rigid gas supply
line. A ⁵⁄₈" diameter line is recommended. Using a wrench
to tighten, connect the gas supply to the grill. Use pipe-
joint compound on all non-flared male threads. Do not
kink or damage the flexible connector when moving the
grill.
Pipe-joint compounds suitable for use with Natural gas
must be used. Do not use Teflon
®
tape.
3. Open the manual shutoff valve in the gas supply line. The
valve is open when the handle is parallel to the gas pipe.
4. Test all connections by brushing on an approved
noncorrosive leak-detection solution. Bubbles will show a
leak. Correct any leak found.
Plug in Grill
1. This built-in outdoor grill comes with a power transformer
plug assembly for the grill lights. Plug in the single-prong plug
in the receptacle on the left underside of the grill.
2. Plug into a grounded 3-prong outdoor outlet.
3. The igniter battery is not factory installed. A 1.5 volt “D” size
alkaline battery is located in the accessory box on the grill
grate. Install battery at this time following the instructions in
“Replacing the Igniter Battery” section.
4. Gently slide grill completely into outdoor enclosure.
5. Now go to the “Check and Adjust the Burners” section.
A. Grill gas pipe
B.New CSA International approved
“outdoor” flexible gas supply line
C.Rear of grill
D.To Natural gas supply
A. Closed valve
B. Open valve
WARNING
Explosion Hazard
Use a new CSA International approved “outdoor”
gas supply line.
Securely tighten all gas connections.
Failure to do so can result in death, explosion, or fire.
A
B
C
D
A
B
A. Single-prong plug
A
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING