KitchenAid KFGR274PSS Gas Grill User Manual


 
pins
7
Installation
Instructions —
Portable Outdoor
Grill
Excessive Weight Hazard
Use two or more people to move
and install grill.
Failure to do so can result in back
or other injury.
WARNING
sear plate
6.Remove sear plates and set aside.
burner
remove
tiedowns
7.Remove tiedowns from burners
and warming shelf.
8.Reinstall sear plates. Make sure
sear plates are resting on pins.
10.Turn on the gas supply. Wait a
few minutes for gas to move through the
gas line.
11.Test all connections by brushing
on an approved non-corrosive leak-
detection solution. Bubbles will show a
leak. Correct any leak found.
12.Go to “Checking and adjusting
the burners” section.
warming
shelf
remove
tiedowns
cover
extension
burner
grate
5.Carefully lift off grill grates and set
aside.
WARNING
Explosion Hazard
Securely tighten all gas connections.
If connected to LP, have a qualified
person make sure gas pressure does
not exceed 11” (28 cm) water column.
Examples of a qualified person
include:
licensed heating personnel,
authorized gas company personnel,
and
authorized service personnel.
Failure to do so can result in death,
explosion, or fire.
9.Make gas connections.
L.P./Propane: A 20 lb. L.P. tank must be
purchased separately. Install the tank into
the compartment below the grill and
screw the hose/regulator assembly to
tank as shown.
The pressure
regulator and
hose assembly
supplied with
the grill must
be used.
Replacement
pressure
regulator and hose assembly specific to
your model, is available from your outdoor
grill dealer.
If converting to natural gas, see
conversion kit requirements and “Gas
supply requirements” section. Follow
instructions included with kit.
hose/regulator
assembly
burner
cap
burner
notch
alignment
tab
1.Move grill into desired outdoor
location.
2.Open the hood.
3.For models equipped with
rotisserie, remove the rotisserie’s skewer
from the grill.
4.For models with side burners:
Remove side burner cover from the top of
the carton that is located on the grill
grate. Remove bubble wrap from side
burner cover and set aside.
Open carton located on the grill grate.
Remove side burner grate, unwrap and
set aside.
Remove burners and burner caps from
carton and unwrap. Install each set of
burners and caps inside the side burner
cavity as shown.
Install side
burner grate
and cover
(with extension
toward grill)
as shown.
Properly dispose
of all packing
material.