KitchenAid KBZU122VSS Outdoor Gas Burner User Manual


 
5
INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.
20 lb LP Gas Models (KBZU122VSS00)
Tools Needed
Parts Supplied
Gas pressure regulator/hose assembly set for 11" WCP LP
gas (attached to manifold)
1 single-prong plug/2,085 mAmp transformer assembly
Convertible regulator set for 4" WCP Natural gas
Orifices for Natural gas conversion
LP gas fuel tank tray
Parts Needed
20 lb LP gas fuel tank - approximately 18" (45.7 cm) height
and 12" (30.5 cm) diameter
Mounting hardware for attaching the tank tray mounting
brackets to the base or floor of the island
Mounting hardware for attaching the power transformer to a
noncombustible surface inside the island cabinet
3-prong outdoor GFI outlet
A bracket or shelf large enough to keep a second 20 lb LP
tank from being stored in the storage area.
Natural Gas Models (KBZU122TSS00, KBZU242TSS00
and KBZU122VSS01)
Tools Needed
Parts Needed
Gas line shutoff valve
½" male pipe thread nipple for connection to pressure
regulator
LP gas-resistant pipe-joint compound
CSA design-certified outdoor flexible stainless steel
appliance connector (4-5 ft [1.2-1.5 m]) or rigid gas supply
line as needed.
Parts Supplied
Convertible regulator set for 4" WCP Natural gas.
Single-prong plug/2,085 mAmp transformer assembly
Tape measure
Small, flat-blade screwdriver
Flat-blade screwdriver
#2 and #3 Phillips screwdriver
Level
Wrench or pliers
Pipe wrench
Scissors or cutting pliers
(to remove tiedowns)
Noncorrosive leak-
detection solution
Tape measure
Small, flat-blade screwdriver
Flat-blade screwdriver
#2 and #3 Phillips screwdriver
Level
Wrench or pliers
Pipe wrench
Scissors or cutting pliers
(to remove tiedowns)
Noncorrosive leak-
detection solution