Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
21
3. Use 6 mm socket and wrench or 6 mm nut driver to remove
the brass orifices from the end of the gas valves.
4. Install new 2.34 mm orifices supplied with this kit to the end
of the gas valve. Use 6 mm socket and wrench or 6 mm nut
driver to tighten.
NOTE: The number 2.34 is stamped on the orifice for
identification.
5. Replace burner by sliding the middle tube (venturi) over the
orifice.
6. Reattach gas burner using 2 screws.
7. Repeat the procedure for each grill burner.
Change the Rotisserie-infrared burner orifice(s)
1. Remove the access cover and screw at the back of the grill
hood with a Phillips screwdriver.
2. Use Phillips screwdriver to remove 2 screws holding the
spider guard to the burner.
3. Use 10 mm wrench to remove the brass orifice located at the
end of the supply pipe.
4. For models with 1 rotisserie burner:
Install 1.9 mm orifice supplied with this kit to the end of the
supply pipe. Use 10 mm wrench to tighten.
For models with 2 rotisserie burners:
Install 1.55 mm orifice supplied with the kit to the end of the
supply pipe. Use 10 mm wrench to tighten.
NOTE: The number 1.9 mm or 1.55 mm is stamped on the
orifice for identification.
5. Replace the spider guard and secure with the 2 screws
removed in Step 2.
6. Repeat the procedure for each rear burner.
Change the Sear burner orifices
(for models equipped with sear burner)
1. Remove the sear burner cover screws. Set the screws and
cover aside.
2. Remove the burner igniter mounting screws.
A.Grill burner orifice
A. Grill burner orifice
A.Burner/orifice connection
B.Burner
A. Two screws
A
A
A
B
A
A. Spider guard
B.Two screws
A. Sear burner cover screws
A
B
A
A